RIM GP-DEMOUNTABLE 2V2392 - Caterpillar

Electrical Connectors
HD-10 Connector- Ensure the plug and receptacle are aligned using the index markings. Rotate the plug until it slips into the receptacle, rotate the coupling approximately one-quarter turn, until a "click" is heard. Ensure the two halves cannot be pulled apart. The acceptable range for the wire installation outside diameter is 2.4 to 3.68 mm. DT Connector- The DT connectors use an orange wedge to lock the pins in place. Check to ensure all seals are present and properly seated. Check pins and sockets before joining connectors. Verify proper alignment and locations of pins and sockets in each connector. Check DT connector locking tab for damage. Replace the connector if tab is damaged. Ensure that the connector is properly locked together (you will hear an audible "click") and that the two mating halves can not be pulled apart. The acceptable range for the wire installation outside diameter is 2.4 to 3.68 mm.
Figure 1.4 Electrical Connectors Do not solder sockets/pins and wires. Sockets/pins should always be crimped onto the wires using the 1U5804 Deutsch Crimp Tool.Deutsch Sealing Plug Insertion
Figure 1.5 Plug Insertion In Unused PinsAll unused connector socket slots must be filled with plugs to insure connector sealing. Proper insertion of connector plugs, used to fill unused pins and socket cavities of connectors, is also critical. The illustration above demonstrates the correct insertion of the plug. The plug cap is designed to rest against the seal, not inserted in the hole in the seal.