RIM AS 3613088 - Caterpillar

3613088 RIM AS Caterpillar parts 775G, 775G LRC, 775G OEM

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3613088
361-3088
3613088

Weight: 447 pounds 202 kg.

Buy RIM AS 3613088 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

General Electric 3613088 Antique Amp Meter Vintage Industrial 39063

$143.77

18 Apr 2022

US: Mara Industrial

General Electric 3613088 Antique Amp Meter Vintage Industrial 39063
General Electric

Number on catalog scheme: 4

For full view, you need register

Compatible equipment models: 3613088:

TRUCK 775G 775G LRC 775G OEM Caterpillar

Information:

Illustration 1 g01626120
Schematic of the "Right Steer Lever Position" sensor
This diagnostic code is recorded when the ECM reads the duty cycle of the sensor as being out of range.The position sensor is a PWM sensor that operates at a frequency of approximately 500 hertz. The sensor has an operating duty cycle of 3.5% to 96.5%.The possible causes of this condition are listed below:
The signal circuit is shorted to the +battery or shorted to ground intermittently.
The signal circuit is open intermittently or the sensor is disconnected.
The sensor may have failed.
The ECM may have failed. This is unlikely.System Response:Note: Ensure that the diagnostic code is active. This procedure can cause new diagnostic codes to be recorded. Ignore these created problems. When the procedure is completed, clear the created diagnostic codes.Note: This diagnostic code is usually an intermittent condition. The diagnostic code may be active or the diagnostic code may not be active.Note: This procedure can cause new diagnostic codes to be recorded. Ignore these created diagnostic codes. When the procedure is completed, clear the created diagnostic codes.Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along contact A (wire C985-BU(Blue)) for the voltage supply.
Turn the key start switch and the disconnect switch to the ON position.
Measure the voltage from contact A (wire C985-BU(Blue)) to contact B (wire J767-GY(Grey)). Expected Result:The voltage is 8 DCV.Results:
OK - The voltage is 8 DCV. Proceed to Test Step 3.
NOT OK - The voltage is not 8 DCV. The circuit is open. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE SIGNAL CIRCUIT OF THE SENSOR.
Turn the key start switch and the disconnect switch to the OFF position.
At the back of the harness connector for the sensor, remove the 7X-1710 Multimeter Probe from contact A and insert the probe along the signal wire (contact C).
At the back of the harness connector for the sensor, insert the 7X-1710 Multimeter Probe along the ground wire (contact B).
Turn the disconnect switch and the key start switch to the