RIM GP-DEMOUNTABLE 3734066 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03375601
Use Tooling (E) and a suitable press to install bearing assembly (16) on pump shaft (12).
Install bearing cone (16D) on the pump shaft.
Install spacer (16C) and bearing cups (16B) on the pump shaft.
Install bearing cone (16A) on the pump shaft.
Illustration 2 g03375550
The splined end of the pump shaft is marked in order to indicate either RH threads or LH threads on the pump shaft. Install pump shaft (12) into Tooling (C). Install bearing locknut (15). Use Tooling (D) (not shown) on the bearing locknut. Tighten the bearing locknut to a torque of 300 30 N m (221 22 lb ft). Note: The torque wrench must be 90 degrees to Tooling (D).
Install set screws (14) and tighten to a torque of 4 1 N m (35 9 lb in) in a 180 degree pattern. Retighten set screws (14) to a torque of 7.2 0.2 N m (63.73 1.77 lb in) in a 180 degree pattern.
Illustration 3 g03375634
Use Tooling (A) and a suitable press to install lip seal (17) in bearing housing (3). Ensure that the lip is toward the outside. Note: Install the lip seal dry. Install the lip seal within 2 minutes of removal from the shipping sleeve.
Illustration 4 g03375643
Lubricate pump shaft (12) with clean engine oil. Install the pump shaft in bearing housing (3). Install retainer (11). Install socket head bolts (10) and tighten to a torque of 12 3 N m (9 2 lb ft).
Illustration 5 g03375150Note: Do not damage the wear surfaces of the carbon ring or the ceramic ring. Do not touch the wear surfaces of the carbon ring or the ceramic ring. Install the ceramic ring with the smoothest face of the ring toward the carbon seal.
Use a suitable press and Tooling (F) to install seal assembly (13) over pump shaft (12) and into housing (3). Ensure that the outer shell of the seal is fully seated in the housing and the installed height of 9.9 0.38 mm (0.388 0.015 inch) is attained.
Lubricate pump shaft (12) on bearing housing (3) with clean engine oil. Position impeller (9) on the pump shaft.
Illustration 6 g01035846
Place bearing housing (3) on impeller (9). Use a suitable press and press pump shaft (12) into the impeller. Install the impeller so the dimension between the impeller and the pump shaft is 0.000 0.076 mm (0.0000 0.0030 inch).
Illustration 7 g01035264
Install O-ring seal (8) on bearing housing (3). Lubricate the O-ring seal with clean engine oil.
Position bearing housing (3) in housing (5). Install the washers and bolts (7) finger tight.
Illustration 8 g01036084
Tighten the bolts in a numerical sequence to a torque of 50 9 N m (35 7 lb ft).
Use Tooling (G) and measure the gap between the impeller and the pump housing. The minimum gap between the impeller and the pump housing is 0.20 mm (0.008 inch).
Illustration 9 g01036014
Install the O-ring seal on plug (6). Install the plug into housing