RIM AS 4633662 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1 Start By:
Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00580930
Typical example
Remove bolt (1). Remove piston cooling jets (2) from the engine. Use Tool (A) in order to turn the crankshaft in a clockwise direction in order to gain access to each of the piston cooling jets. Repeat this process for all of the piston cooling jets. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1
B 5P-8709 Cooling Jet Alignment Tool 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g00580930
Typical example
Check the alignment of the piston cooling jets (2) with Tool (B). Refer to Special Instructions, SMHS7267, "Use Of 5P-8709 Tool Group for Alignment Of Piston Cooling Jets" for the correct alignment procedure.
Install piston cooling jets (2) on the engine. Tighten bolt (1) to a torque of 25 7 N m (18 5 lb ft). Use Tool (A) in order to turn the crankshaft in a clockwise direction in order to gain access to each of the piston cooling jets. Repeat this process for all of the piston cooling jets. End By:
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".