RIM 4V5376 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 263-3554 Axle Lifting Lug 1
B 377-5783 Tool-Ratchet As 1
1U-6221 Hydraulic Torque Wrench Gp 1
3S-6224
or
8S-8033 Electric Hydraulic Pump Gp (115-VOLT)
Electric Hydraulic Pump Gp (230-VOLT) 1 Start By:
Remove the axle assembly from the machine. Refer to Disassembly and Assembly, "Fixed Axle (Front) - Remove" or Disassembly and Assembly, "Oscillating Axle (Rear) - Remove".
Remove the axle shafts. Refer to Disassembly and Assembly, "Axle Shaft - Remove". Note: The procedures for removing the front final drive and brake assemblies and the rear final drive and brake assemblies are the same.Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses, and all tubes in order to prevent fluid loss and contaminants from entering the system.
Illustration 1 g01093679
Disconnect hose assembly (2) (if equipped), from final drive and brake (1).
Disconnect two hose assemblies (3) and (4) from final drive and brake (1).
Illustration 2 g01093242
Position the rear axle assembly on a suitable stand or block in position, as shown.
Attach Tooling (A) and a suitable lifting device to final drive and brake (1). The weight of final drive and brake (1) is approximately 960 kg (2120 lb).
Illustration 3 g01093244
Install Tooling (B) and remove 22 nuts (5) from final drive and brake (1).
Remove the final drive and brake (1) from the axle housing.
Illustration 4 g01093254
Remove O-ring seal (6) from final drive and brake (1).