RIM GP-DEMOUNTABLE 5247390 - Caterpillar

Illustration 8: Schematic.Diagnostic Codes
Functional Test
1: Check For Connector Damage1. Remove power from the control system. Turn the Mode Control Switch (MCS) to the OFF/RESET position. Open the fuse breaker in the ESS Panel.2. Check the Electronic Control Module (ECM) Connector, Terminal Strip Connections in the ESS Panel, the desired speed signal, and the Desired Speed Potentiometer for corrosion or mechanical failure. (Refer to Section 2: P-002: Inspecting Electrical Connectors Of The G3600 Engine Troubleshooting manual for details.)3. Install the fuse in the ESS Panel.4. Check the harness and wiring for abrasion and pinch points from the sensor back to the ECM. All connectors/pins/sockets should be completely mated/inserted and the harness/wiring should be free of corrosion, abrasion, or pinch points.* If OK and the connectors are in good condition, proceed to Step 2.* If not OK, repair or replace the faulty connector. STOP.2: Check For Power To The Remote Speed Control1. Apply power to