RIM AS 9U4808 - Caterpillar

Adding a Restraining Device to the Boom and Stick Arrangement for Road Travel
The following procedures are designed in order to secure the boom and stick arrangement on a side shift machine.
Illustration 1 g00632894
This is the correct position for machine roading. The arrows indicate the positions for routing the 160-7599 Bucket Restrainer (1) .
Position the implements for machine roading. Refer to Illustration 1 and refer to the Operation and Maintenance Manual.
Illustration 2 g00632900
(1) 160-7599 Bucket Restrainer (A) Boom (B) Bracket of bucket assembly (C) Link assembly (D) Ratchet of the bucket restrainer (E) Swing frame
Route one end of the 160-7599 Bucket Restrainer (1) between the boom (A) and the swing frame (E). Refer to Illustration 2.
Route the other end of the bucket restrainer (1) around the bracket assembly (B) on the bucket. This end of the bucket restrainer must also be passed under the link assembly (C). Refer to Illustration 2.
Connect the two ends of the bucket restrainer together. Use the ratchet (D) to tighten the strap of the bucket restrainer. Do not allow the strap to be tightened excessively.Note: Remove the bucket restrainer before you begin any movements of the backhoe. The bucket restrainer can be loosened by pulling the locking plate of the ratchet toward the handle of the ratchet.Adding a Restraining Device to the Loader Bucket Lift Arms for Road Travel
The following procedures and parts have been developed for use on backhoe loaders with standard parallel lift machine configurations.
Illustration 3 g00632903
(F) Lift arm (G) Boss (H) Link assembly
Move the loader bucket and lift arm to the correct position for machine roading. Refer to the machine's Operation and Maintenance Manual for instructions on machine roading. Refer to Illustration 3.
Find the boss (G) on the right side lift arm. Refer to Illustration 3.
Illustration 4 g00632909
(2) 126-4974 Plate (G) Boss (H) Link assemblies
Insert the 126-4974 Plate (2) through the link assemblies (H). The plate is then placed over the boss (G). Refer to Illustration 4.
Illustration 5 g00632922
(2) 126-4974 Plate (3) 5P-0370 Lock Pin (4) 134-4807 Pin (G) Boss
Insert the 134-4807 Pin (4) through the 126-4974 Plate (2) and the boss (G). Refer to Illustration 5.
Secure the pin (4) with a 5P-0370 Lock Pin (3). Refer to Illustration 5.Note: Remove the 126-4974 Plate before you operate the lift arm. Failure to remove the plate could result in damage to the machine.Note: The 126-4974 Plate is used exclusively on standard parallel lift machine configurations. Machines with standard lift arrangements cannot use the plate.Placement of the Instruction Film
Illustration 6 g00633247
The boom and stick arrangement which is positioned for machine roading reaches the height which is shown in the illustration.As part of every 156-5126 Certification Conversion Arrangement , a 160-5900 Film is included. The film commands the operator to install the 160-7599 Bucket Restrainer and the 126-4974 Plate prior to machine roading.The film must be applied to the lower left hand corner of the front window of the