RING-RETAINING 0616708 - Caterpillar

Put the carrier assembly on a suitable block, as shown. Use a screwdriver to compress the retainer ring. Remove gear (114) from the carrier assembly. Remove retaining ring (115).
Illustration 61 g01887213
Remove spiral lockring (116). Use Tooling (G) to remove bearing (117) from the carrier. Remove seal rings (118).
Illustration 62 g01887215
Use a hammer and a punch to push spring pin (119) from the carrier assembly.
Illustration 63 g01887216
Remove shaft (128), thrust discs (120), (123), (124) and (127), and gears (122) and (126). Remove bearings (121) and (125) from the gears. Remove pin (119) from shaft (128).
Repeat Steps 88 and 89 for the remaining gears.
Illustration 64 g03702590
Remove O-ring seals (129).
Illustration 65 g03702712
Remove gear (130) from the shaft assembly and remove seals (131) from the seal carrier.
Illustration 66 g01887218
Remove spiral lockring (132) from the shaft assembly.
Illustration 67 g01887219
Put shaft assembly on suitable blocks, as shown. Use a soft hammer to strike shaft assembly (134) until the bearing is removed from shaft assembly (133).
Illustration 68 g01889333
Remove retaining ring (135) from the shaft assembly. Remove bearing (136).
Illustration 69 g03702733
Remove O-ring seal (137).
Illustration 70 g03702741
Use Tooling (H) and a suitable press to remove seal carrier (138) from the shaft assembly.
Illustration 71 g03702848
Use Tooling (L) to remove bearing (139) from the shaft assembly.
Illustration 72 g03702850
Remove gear (140) from the clutch housing.
Remove piston (141) from the clutch housing.
Illustration 73 g03702852
Remove seals (142) and (143) from the piston (141).
Illustration 74 g03702855
Remove spiral lockring (144). Use Tooling (G) to remove bearing (145) from the housing.