RING 0997811 - Caterpillar

Illustration 1 g01015347
If your units are meters, do one of the following.
Press the soft key ("Default Set 0.300") in order to set the tolerance to the default value of0.300 m (0.98 ft).
Press the soft key ("Half Set 0.150") in order to set the range to half the current range. For example, the value will be 0.150 m (0.49 ft). In order to continue to divide the current setting by two, press this soft key again. The value shown on the soft key will reflect the value for the "On-Grade Tolerance". The "On-Grade Tolerance" will be set when you press the soft key.
Press the soft key ("Double Set 0.600") in order to set the tolerance to double the current tolerance. For example, the value will be 0.600 m (1.97 ft). In order to continue to double the current setting, press this soft key again. The value that is shown on the soft key reflects the value for the "On-Grade Tolerance". The "On-Grade Tolerance" will be set when you press the soft key.
You may also use the arrow keys in order to manually enter the "On-Grade Tolerance".
Do one of the following.
Press the "OK" key in order to save the settings and return to the "Setup Menu – Configuration" dialog.
Press the "ESC" key and then press the "OK" key in order to return to the "Setup Menu – Configuration" dialog without saving the changes.
Press the "ESC" key in order to exit the "Setup Menu – Configuration" dialog. The changes take effect immediately.Note: Press the "OK" key in order to save the settings. The CAESbasic system will check the value that was entered against the maximum and the minimum value. An error message appears if these limits are exceeded.