RING-RETAINING 1096494 - Caterpillar

Illustration 1 g00865327
Note: Assemble this linkage on the machine by rotating the rod end of the bucket cylinder and by positioning the grease fitting away from the stick. Coat all the bores for pins with lubricant. (1) 189-3923 Pin Diameter after plating ... 89.85 0.04 mm (3.537 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (2) 166-1487 Shim thickness ... 2.0 mm (0.08 inch)Note: Locate the above shim next to the power link. (3) Lubricate the sealing lip slightly with the lubricant that is being sealed.Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (4) 203-7326 Sleeve Bearing Quantity ... 2 Outside diameter ... 106.200 0.013 mm (4.1811 0.0005 inch) Inside diameter ... 90.270 0.020 mm (3.5539 0.0008 inch) Install the bearing in the bearing bore. ... 9.5 0.3 mm (0.37 0.01 inch) (5) 189-3922 Pin Diameter after plating ... 69.85 0.04 mm (2.750 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (6) Position the four nuts past the end of the four bolts. ... 0.5 0.5 mm (0.02 0.02 inch) (7) Tighten the four nuts against four nuts (6). (8) 7Y-3549 Pin Diameter after plating ... 79.85 0.04 mm (3.144 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch)Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (9) 203-7322 Sleeve Bearing Quantity ... 2 Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.250 0.020 mm (3.1594 0.0008 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (0.37 0.03 inch) (10) 7Y-3550 Pin Diameter after plating ... 89.85 0.04 mm (3.537 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch)