RING 1193999 - Caterpillar

Illustration 1 g03485478
Under the "Communications" tab, change the connection type to "Ethernet Direct Connection" (Illustration 2).
Illustration 2 g03485516
Select the "Network Adapter Connection" that supports the "Ethernet Direct Connection" (Illustration 3). If using the optional USB to Ethernet Adapter, be sure to select this device from the drop-down menu.
Illustration 3 g03485581
Cat ET may attempt to reconnect based on the change of Communication Protocol. Click "Yes" (Illustration 4).
Illustration 4 g03485596
When Cat ET reconnects, Cat ET will attempt to detect an ECM using "IP Data Link" (Illustration 5).
Illustration 5 g03485758
Select the Flash File when the ECM is detected. Initiate the Flash process (Illustration 6).Note: Wait until Cat ET shows 100% completed, even if the display looks like it is working during Flashing.
Illustration 6 g03485796
Click "OK" when Cat ET provides a warning that the Operating System will be changed.
Illustration 7 g03485900
During the Flashing process, the screens shown in Illustration 8 through 10 will be displayed.Note: Wait until the Flash Process has completed.
Illustration 8 g03487493
Illustration 9 g03487401
Illustration 10 g06014093Note: Wait until "Flash Completed Successfully" displays. Click "Cat ET".
Illustration 11 g03494458
After Flashing, change Communication settings back to "Comm Adapter 3" (or "Comm Adapter 2").
Illustration 12 g03494483
Connect to Cat ET.
Go to Display "Configurations".
Verify that the Product ID matches the Machine Product ID. If the Product ID does not match, change the cycle power to the machine. Changing the cycle power to the machine allows the Display to re-request the Product ID from the Machine ECM. (Illustration 13).Note: This machine cannot manually change product ID configuration. This is supported in the ECM summary screen in ET, but not in the configuration area.Note: Illustration 13 is a sample screenshot for D9T REX00301. New Flashing information will be different.
Illustration 13 g03494716Flashing Example
The following is an example of approximate numbers and timing recorded during a Flash with no bus traffic:Note: Data Link traffic and timing will vary between machines.
Cat ET shows 18% at 16 seconds.
Cat ET shows 45% at approximately 26 seconds.
Reboot at 38 seconds.
Eboot erasing at 48 seconds.
Eboot loading done at 1:04.
Erasing NOR at 1:05.
Erasing NOR OS space ends at 2:37.
Programming OS starts at 2:38.
Programming OS ends at 6:14.
Display has rebooted, but is older cab file at 6:30.
Cat ET shows 50% at 6:38.
Cat ET shows 90% at 6:45.
Reboots.
Cab file extraction at 7:07.
Reboots and shows new cab file at 8:09.
Cat ET shows 100% at 8:19.