1528071 RING-THRUST Caterpillar parts
1190, 1190T, 1390, 2390, 2391, 322C, 324D FM, 325C FM, 325C L, 325D FM, 325D FM LL, 521, 522, 527, 541, 963B, 963C, 963D, D6G2 LGP, D6G2 XL, D6H, D6H XL, D6H XR, D6M, D6R, D6R II, D6R III, D6R STD, D6...
Rating:
Alternative (cross code) number:
CA1528071
152-8071
1528071
CA1528071
152-8071
1528071
Weight: 0.09 pounds 0 kg.
Information:
ID
45
mm
OD
52.1
mm
WIDTH
10.7
mm
EXCAVATOR, UNDERCARRIAGE,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$9.77
08 Jun 2022
US: Florida-Parts-Z
1528071 - Ring for Caterpillar (CAT)
FIRST PRICE PARTS
FIRST PRICE PARTS
$8.36
08 Jan 2019
CATERPILLAR AFTERMARKET: CATERPILLAR AFT
Caterpillar Ring - Thrust 1528071 New
$7.94
11 Aug 2020
0.110231131[0.00] Pounds
-: -
CTP Caterpillar Ring (1528071)
This part in 2 request:
Show.
This information for suppliers only!
2018-01-15
2017-11-24
Number on catalog scheme:
6
For full view, you need register
Compatible equipment models: 1528071:
Information:
Transmission, SPN 1079 FMI 1Conditions Which Generate This Code:
Illustration 1 g01343715
Connections of the 5 Volt Supply
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides 5 DCV in order to operate the oil temperature sensor. The control module shall monitor sensor supply voltage for a low voltage condition. If the voltage drops below 4 DCV for 5 seconds, a diagnostic code is generated. The delay will prevent a diagnostic code from being logged when the machine is started. The diagnostic code will be cleared when the voltage is above 4.2 DCV for 5 seconds.The results of this diagnostic code are listed:
All of the associated sensors will also log diagnostic codes.
When this diagnostic code occurs, the action lamp and the action alarm are ON.The possible causes of the diagnostic code are listed:
The supply circuit (wire R977-OR(Orange)) is shorted to the ground circuit in the machine harness.
The ECM has failed. This is unlikely.Test Step 1. CHECK THE SENSOR.
Ensure that the diagnostic code is present. The diagnostic code should be active.
Observe the status of the diagnostic code.
Disconnect the machine harness from the sensor. Expected Result:The diagnostic code is NO longer active. Results:
OK - The diagnostic code is NO longer active.Repair: The sensor has failed. Replace the sensor.STOP
NOT OK - The diagnostic code remains active. The sensor is NOT causing the diagnostic code. Proceed to test step 2.Test Step 2. CHECK FOR SHORT TO GROUND
The sensor remains disconnected from the machine harness.
Turn the disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the ECM, measure the resistance between the contact of the sensor supply voltage and frame ground. Expected Result:The resistance that is measured should be greater than 5000 ohms. Results:
OK - The resistance that is measured is greater than 5000 ohms. The harness circuit is correct. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this diagnostic code procedure and perform this diagnostic code procedure again. Replace the ECM if the cause of the diagnostic code is NOT found. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". STOP
NOT OK - The resistance that is measured is less than 5000 ohms.Repair: The machine harness has failed. There is a short between frame ground and the contact for the sensor supply voltage in the machine harness. Repair the machine harness or replace the machine harness. STOP
Illustration 1 g01343715
Connections of the 5 Volt Supply
The sensor supply is a power supply that is internal to the ECM. The sensor supply provides 5 DCV in order to operate the oil temperature sensor. The control module shall monitor sensor supply voltage for a low voltage condition. If the voltage drops below 4 DCV for 5 seconds, a diagnostic code is generated. The delay will prevent a diagnostic code from being logged when the machine is started. The diagnostic code will be cleared when the voltage is above 4.2 DCV for 5 seconds.The results of this diagnostic code are listed:
All of the associated sensors will also log diagnostic codes.
When this diagnostic code occurs, the action lamp and the action alarm are ON.The possible causes of the diagnostic code are listed:
The supply circuit (wire R977-OR(Orange)) is shorted to the ground circuit in the machine harness.
The ECM has failed. This is unlikely.Test Step 1. CHECK THE SENSOR.
Ensure that the diagnostic code is present. The diagnostic code should be active.
Observe the status of the diagnostic code.
Disconnect the machine harness from the sensor. Expected Result:The diagnostic code is NO longer active. Results:
OK - The diagnostic code is NO longer active.Repair: The sensor has failed. Replace the sensor.STOP
NOT OK - The diagnostic code remains active. The sensor is NOT causing the diagnostic code. Proceed to test step 2.Test Step 2. CHECK FOR SHORT TO GROUND
The sensor remains disconnected from the machine harness.
Turn the disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the ECM, measure the resistance between the contact of the sensor supply voltage and frame ground. Expected Result:The resistance that is measured should be greater than 5000 ohms. Results:
OK - The resistance that is measured is greater than 5000 ohms. The harness circuit is correct. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this diagnostic code procedure and perform this diagnostic code procedure again. Replace the ECM if the cause of the diagnostic code is NOT found. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". STOP
NOT OK - The resistance that is measured is less than 5000 ohms.Repair: The machine harness has failed. There is a short between frame ground and the contact for the sensor supply voltage in the machine harness. Repair the machine harness or replace the machine harness. STOP
Cat SIS web machinery list:
Parts ring Caterpillar catalog:
320D, 320E, 320E L, 320E RR, 321B, 321C, 321D LCR, 322B, 322C, 325C L
322C, 322C FM, 324D FM, 324D FM LL, 325C, 325C FM, 325C L, 325D FM, 325D FM LL, 325D L, 325D MH, 328D LCR, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336...
322C, 322C FM, 324D FM, 324D FM LL, 325C, 325C FM, 325C L, 325D FM, 325D FM LL, 325D L, 325D MH, 328D LCR, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336...
1390, 2590, 320C, 320D, 320D FM, 320D2, 320D2 L, 322C, 323D L, 323D LN, 323D SA, 324D, 324D FM, 324D L, 324D LN, 325C, 325D, 325D FM, 325D L, 329D L, 329D LN, 329E, 330D MH, 521B, 522B, 541, 541 2, 55...
320C, 325B L, 325C, 325C L, 325D MH, 330C, M325B
1190T, 1290T, 2391, 2491, 522, 522B, 532, 552, 552 2, TK722, TK732, TK752
323D L, 323D LN, 324D, 324D FM, 324D L, 324D LN, 324E L, 324E LN, 325D, 325D FM, 325D L, 329D L, 329D LN, 329E L, 329E LN, 330D L
323D L, 323D LN, 324D, 324D FM, 324D L, 324D LN, 324E L, 324E LN, 325D, 325D FM, 325D L, 329D L, 329D LN, 329E L, 329E LN, 330D L
323D L, 323D LN, 324D, 324D FM, 324D L, 324D LN, 324E L, 324E LN, 325D, 325D FM, 325D L, 329D L, 329D LN, 329E L, 329E LN, 330D L
325 L, 325C, 328D LCR, 330, 330 FM L, 330 L, 330B, 330B L, 330C, 330C FM, 330C L, 330C MH, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 345B II, 345C, 345C L, 365B, 365B II, 365B L, 365C, 36...
325B L, 325C FM, 325D FM, 325D FM LL, 330B L, 330C FM, 330D FM, 350, 350 L, CR20, M325B, M325C MH, M325D L MH, P16, S25
325C, 325C L, 325D, 325D L, 328D LCR, 329D, 329D L
1700792
RING
D6R, D6R II, D6R III, D6T, D6T LGP, D6T LGPPAT, D6T XL
D6R, D6R II, D6R III, D6T, D6T LGP, D6T LGPPAT, D6T XL
583R, 589, 963C, 973, 973C, 973D, 977H, 977K, 977L, 983, 983B, D11R, D6R, D8K, D8R, D8R II, D8T, D9N, D9R
517, 527, 583T, D5HTSK II, D6H, D6H II, D6H XL, D6H XR, D6R, D6R II, D6R III, D6R STD, D6T, D6T LGP, D6T LGPPAT, D6T XL, D8N, D8R, D8R II, D8T, PL83
572R, D6R, D6R II, D7R, D7R II, D8R II
572R, 572R II, 578, 583R, 583T, 587T, 615, 615C, 814B, 814F, 815B, 815F, 816F, 966D, 966F, 966F II, 970F, 980C, 980F, 980F II, 980G, 980G II, 980H, 980K, D25C, D300B, D6H, D6H XL, D6H XR, D6R, D6R II,...
572R, 615, 814B, 815B, 966D, 966F, 966F II, 970F, 980C, 980F, 980F II, D250B, D25C, D25D, D300B, D6H, D6H XL, D6H XR, D6R, D7H, D7R, D8N
330B L, 735, 740, 772B, 773B, 775B, 777B, 784B, 785, 785B, 789, 789B, 973C, 973D, D350E II, D400E II, OEMS
D6R, D6R II
365B, 365B II, 365C, 385C, 385C FS, 5080, 5090B, 621, 621B, 623B, 623E, 631C, 666, 776, 789, 789B, 789C, 789D, 7A, 824G II, 824H, 834G, 834H, 8A, 928HZ, 930G, 950B, 950B/950E, 950F, 950F II, 950G, 950...
14E, 4S, 572G, 583K, 5S, 613, 613B, 6A, 6S, 772, 773B, 773D, 775B, 775D, 776C, 776D, 777, 777D, 814, 814B, 814F, 814F II, 814S, 815, 815B, 815F, 815F II, 920, 930, 941, 950, 966C, D5B, D5E, D6D, D6E, ...
24H, 24M, 527, 963, 963B, 963C, 963D, D6G, D6G2 LGP, D6G2 XL, D6H, D6H XL, D6H XR, D6R, D6R II, D6R III, D6T, D6T LGP
D6H, D6H XL, D6H XR, D6R, D6R II, D6R III, D6R STD, D6T, D6T LGP, D6T LGPPAT, D6T XL, D7E, D7E LGP