RING-METAL SEAL 1752582 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
B     193-8094     Spline Socket     1    
C     1P-0510     Driver Gp     1    
D     5P-4758     Retaining Ring Pliers As     1    
E     280-2059     Spanner Wrench Assembly     1    
H     FT-2462     Tube     1    
J     1P-0520     Driver Gp     1    
K     9S-8096     Seal Installer Sleeve     1    
L     4C-4030     Thread Lock Compound     -    
M     154-9731     Thread Lock Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Assemble the Pump
Illustration 1 g01646638
Illustration 2 g01648125
Dimension (A) is 90 degrees.Note: Thoroughly clean the threads of shaft assembly (26) and locknut (29) with solvent before assembly.
Raise the temperature of bearing (30) . Install bearing (30) on shaft assembly (26) .
Apply Tooling (N) to the threads and face of locknut (29) . Orient the tapered end of locknut (29) toward bearing (30) . Install locknut (29) on shaft assembly (26) . Use Tooling (B) and Tooling (E) to tighten locknut (29) to a torque of 135 15 N m (100 11 lb ft).
Illustration 3 g01723243
Lower the temperature of bearing race (34) . Use Tooling (J) to install bearing race (34) in bearing housing (22) .
Illustration 4 g01647233
Use Tooling (H) , Tooling (J) , and a suitable press to install shaft assembly (26) and bearing (30) into bearing housing (22) . Use Tooling (D) to install retaining ring (25) .
Illustration 5 g01647715
Position bearing housing (22) on suitable cribbing, as shown. Ensure that the shaft assembly is supported. Raise the temperature of roller bearing (33) . Install roller bearing (33) into bearing housing (22) .Alternatively, use a suitable press with an appropriate sleeve to press the bearing into the housing.
Use Tooling (D) to install retaining ring (32) .
Illustration 6 g01647718
Illustration 7 g01647854
Install the O-ring seal on shaft assembly (26) .