RING-RETAINING 1836233 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Strap Wrench 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g02475535
Place a suitable container below engine oil filter base (5) in order to catch any oil that might be spilled.
Use Tooling (A) to remove engine oil filter (5). Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure.
Remove bolts (3).
Remove engine oil filter base (4).
Remove gasket (6).
If necessary, remove plug (1) from engine oil filter base (4). Remove O-ring seal (2) from plug (1). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g02475535
Clean engine oil filter base (4). Clean the gasket surfaces of the cylinder block.
If necessary, install new O-ring seals (2) to plugs (1). Install plugs (1) to engine oil filter base (4). Tighten the plugs to a torque of 12 N m (106 lb in).
Install bolts (3) to engine oil filter base (4).
Install a gasket (6) onto bolts (3). Install the assembly of the engine oil filter base to the cylinder block.
Tighten bolts (3) to a torque of 22 N m (195 lb in).
Install a new engine oil filter (5) and check the level of the engine lubricating oil. Refer to Operation and Maintenance Manual, "Engine Oil Level - Check" for the correct procedure.