RING-RETAINING 1G6974 - Caterpillar

Performing the Measure Up
Park the vehicle on a flat concrete floor.
Illustration 23 g02654346
Top and side views of light vehicleNote: Enter the correct details. Any errors transfer directly into the finished surface.Note: The origin is the position on the ground under the center of the front of the vehicle.
Measure the machine satellite receiver offsets.Note: The "X" measurement that is taken to the left of the centerline of the vehicle will be a negative number. The "X" measurement that is taken to the right of the centerline of the vehicle will be a positive number.Note: The "Y" measurement is a positive number if the antenna is in front of the origin. The "Y" measurement is a negative number if the antenna is behind the origin.
GPS x: Measure the distance from the centerline of the vehicle to the center of the satellite receiver.
GPS y: Measure the distance from the front of the vehicle to the center of the satellite receiver.
Illustration 24 g02716317
(19) MS992 satellite receiver (20) Phase center (approximate)Note: Instructions on how to find the phase center (20) are written on the base of the satellite receiver. For the MS992 satellite receiver (19), the phase center is 12.8 cm (5.0 inch) from the bottom of the satellite receiver.Note: The GPS z: measurement is taken from the ground up to the phase center.
GPS z: Project a horizontal line through the center of the front of the bumper. Follow this line to the ground under the bumper. Measure the distance perpendicular to this line up to the horizontal line going through the phase center (2) of the satellite receiver (1) .
Move the origin of the vehicle to a known point.
Compare the Northing, Easting, and Elevation.Rebooting the Mobile Software
Once the mach_cfg.txt files are on the portable PC, reboot the mobile software. Use one of the following methods:
Portable PC only
Portable PC and office combinedPortable PC Only Restart
Close the mobile software.
Start the mobile software.Portable PC and Office Combined Restart
In Cat MineStar System, select the machine to be rebooted.
Right-click on the machine and select "Reboot". The reboot command closes the mobile software on the portable PC.
Manually restart the software.ReferenceFor more information, refer to Systems Operation, RENR9562, "Terrain Office Software".Using the Screen Configuration Utility
Use the Screen Configuration Utility (SCU) to configure windows and screens in CAESutltra. Each version of CAESultra uses the SCU with the same version number as CAESultra. Therefore, multiple versions of SCU may be present on a PC or portable PC. SCU is not upgraded. Instead, each new version is downloaded.Obtain CAESultra v4.0 SCU security keys before opening the SCU. When first opening the SCU on Windows XP or Windows 7 32-bit operating systems, follow the directions on the screen to install. When first opening the SCU on a Windows 7 64-bit system, follow the instructions below.Installing SCU on a Windows 64-bit System
Upon initial installation of the v4.1 SCU on a Microsoft Windows 64-bit operating system, the user will see a security error and a TMAC error. The workaround for these errors involves the following tasks:
Updating the