RING-PISTON 1P8474 - Caterpillar

Recording the final value of each menu item is recommended by Caterpillar. A space is provided below for recording each value. This can be helpful if the control needs reprogramming or replacement.Use the line below for the Part No. and Revision letter of the software:____________________
Table 1
CONFIGURE MODE    
"CFIG OPTION"     Default     Current Setting    
"USE REV ACTUATOR"     #FALSE        
"USE 2nd DYNAMICS"     #TRUE        
"DYNAMICS 1 CONSTANT"     #FALSE        
"USE TORSION FILTER"     #TRUE        
"USE AIR MAN LIMIT"     #TRUE        
"USE TORQ LIMIT"     #TRUE        
"RESET ALM ON CLEAR"     #TRUE        
"NON-LATCH ALM DOUT3"     #FALSE        
"CFIG SPEED CONTROL"     Default (Low, High)     Current Setting    
"RATED SPEED(RPM)"     #1200 (1, 2100)        
"ASPD #1 TEETH"     #16 (16, 500)        
"ASPD 1 MAX FREQ(HZ)"     #5000 (10, 17500)        
"ASPD #2 TEETH"     #16 (16, 500)        
"ASPD 2 MAX FREQ(HZ)"     #5000 (10, 17500)        
"REVERSE ACTING"     #FALSE        
"DSPD #1 TEETH"     #16 (16, 500)        
"DSPD #2 TEETH"     #16 (16, 500)        
"CFIG INDICATION"     Default     Current Setting    
"ON MAX LIMIT"     #FALSE        
"ON AIR PRESS LIMIT"     #FALSE        
"ON TORSION LIMIT"     #FALSE        
"ON TORQUE LIMIT"     #FALSE        
"ACT SHUTDOWN"     #FALSE        
"SPEED SWITCH"     #FALSE        
"OIL XMTR FAULT"     #FALSE        
"WATER XMTR FAULT"     #FALSE        
"AIR XMTR FAULT"     #FALSE        
"LOAD SWITCH"     #FALSE        
"CFIG ALARMS"     Default     Current Setting    
"SPEED #1 FAIL"     #FALSE        
"SPEED #2 FAIL"     #FALSE        
"SPD #1 AND #2 FAIL"     #FALSE        
"REMOTE SR FAIL"     #FALSE        
"LOW OIL PR ALARM"     #FALSE        
"HI FUEL DEMAND ALARM"     #FALSE        
"HI SPEED ALARM"     #FALSE        
"LOW WATER PR ALARM"     #FALSE        
"HIGH TORSIONAL LEVEL"     #FALSE        
"SPEED SWITCH ALM"     #FALSE        
"LOAD SWITCH ALM"     #FALSE        
"CFIG SHUTDOWNS"     Default (Low, High)     Current Setting    
"SPEED #1 FAIL"     #FALSE        
"SPEED #2 FAIL"     #FALSE        
"SPD #1 AND #2 FAIL"     #FALSE        
"REM SPEED REF FAIL"     #FALSE        
"LOW LUBE OIL PR SD"     #FALSE        
"HI FUEL DEMND SD"     #FALSE        
"HI SPEED SD"     #FALSE        
"LOW WATER PR SD"     #FALSE        
"HIGH TORSION LVL"     #FALSE        
"SD BYPASS SPEED(RPM)"     #200.0 (0.0, 2200.0)        
"SD