RING-RETAINING 2129436 - Caterpillar

(K) Washer. (L) Align Holes. (M) First Forward Position. (N) First Reverse Position. (O) Neutral Position.Torque for the 1/4 in. nuts that hold the rod ends on the cable ... 8 5 N m (6 4 lb ft)Torque for the 5/8 in. cable nuts ... 38 2 N m (28 1 lb ft)(1) Torque for nut ... 14 4 N m (10 3 lb ft)(3) 4B-8710 Spring: Length under test force ... 33.33 mm (1.312 in)Test force ... 240 N (54 lb)Free length after test ... 49.21 mm (1.937 in)Outside diameter ... 17.35 mm (.683 in)(B) Dimension to assemble bolt ... 52.0 1.0 mm (2.05 .04 in)(C) Back of rod end to end of exposed threads on cable assembly (upper end) ... floating dimension, "rough" starting point 14.0 mm (.55 in)(D) Top of floorplate to top of exposed threats on cable assembly ... 22.0 1.5 mm (.87 .06 in)(E) Face of plate to end of exposed threats on cable assembly ... 31.0 1.5 mm (1.22 .06 in)(F) Back of yolk to end of exposed threads on cable assembly (lower end) ... 8.5 1.5 mm (.33 .06 in)Transmission Cable Adjustment
1. Remove cable rod end (5) from lever (4).2. Assemble cable assembly to dimensions (D view I-I), (E), and (F view H-H).3. From the upper end, push cable into sheath until valve spool is in last detent position. This is the SECOND REVERSE speed position.4. Pull on cable rod end (5) until valve spool moves two detent positions. (This is NEUTRAL position.)5. Place hand lever (2) in neutral position (view J-J). Make certain hand lever seats firmly in the "V notch". If it does not, readjustment of bolt dimension (B) may be required.6. Adjust rod end (5) so that rod end bore and hole in lever (4) are aligned (view G-G). Adjustment must account for system backlash by gently pushing and pulling end of cable to determine center of backlash zone.7. Position washer between rod end (5) and lever (4). Install and torque bolt. (View A-A) Torque jam nut to rod end (5).8. In the cab, check hand lever (2) position in first forward and first reverse relative to the corners of the "V notch". The distance should be equal. X=Y (see view J-J). Be aware of system backlash when making this comparison.9. If necessary, adjust rod end (5) again.10. As a final check move hand lever (2) into all speed positions to ensure proper adjustment. Also check if neutral start switch functions properly. The starter should engage only in the neutral position.