RING (STANDARD) 2S6442 - Caterpillar

During normal operation, each pressure sensor outputs a signal voltage that accurately represents the pressure that is sensed by the sensor. However, certain circuit conditions can cause a signal voltage to become inaccurate.During each key on event of at least 2 seconds, the Electronic Control Module (ECM) evaluates the signal voltage from each pressure sensor. The ECM compares each signal voltage to a reference voltage. The reference voltage that is used depends on the sensor.If a signal voltage is close to the reference voltage, the ECM will internally adjust the signal voltage. The internal adjustment causes the pressure value for the sensor to be correct. This process is called automatic sensor calibration.If a signal voltage is not close to the reference voltage, the ECM will not internally adjust the signal voltage. The ECM will set a fault code that indicates there is a problem with the signal voltage.Table 1 indicates the maximum error that is permitted for each sensor, and the reference for that sensor. Refer to the troubleshooting procedure to determine the root cause of the incorrect signal voltage.Clear all "Active" codes using Cat ET before proceeding with the following procedure. Refer to Troubleshooting, "Diagnostic Capabilities - Clearing Active Codes for On Board Diagnostics (OBD)" for more information on clearing "Active" codes.
Table 1
Diagnostic Trouble Codes    
CDL Code     J1939 Code     Code Description
(code descriptions may vary)     Comments    
100-13     100-13     Engine Oil Pressure Sensor : Out of Calibration     During key on, the signal voltage from the engine oil pressure sensor indicated an engine oil pressure greater than +/-
54 kPa (8 psi) from the atmospheric pressure sensor.
Reference sensor : Atmospheric Pressure Sensor    
101-13     101-13     Crankcase Air Pressure Sensor : Out of Calibration     During key on, the signal voltage from the crankcase air pressure sensor indicated a crankcase air pressure greater than +/-
1.5 kPa (0.2 psi).
There is not a reference sensor for this sensor    
274-13     108-13     Atmospheric Pressure Sensor : Out of Calibration     During key on, the signal voltage from the atmospheric pressure sensor indicated an atmospheric pressure other than
0 kPa (0 psi).
This sensor is used as a reference sensor    
289-13     5578-13     Fuel Pressure Sensor - Before Fuel Filter : Out of Calibration     During key on, the signal voltage from the unfiltered fuel pressure sensor (absolute) indicated an unfiltered fuel pressure greater than +/-
67 kPa (10 psi) from the fuel outlet pressure sensor (after secondary fuel filter).
Reference sensor : Fuel Pressure Sensor - After Fuel Filter    
460-13     5580-13     Fuel Pressure Sensor - After Fuel Filter : Out of Calibration     During key on, the signal voltage from the fuel outlet pressure sensor (after secondary fuel filter) indicated a pressure other than
0 kPa (0 psi).
This sensor is used as a reference sensor    
1785-13     3563-13     Intake Manifold Pressure Sensor : Out of Calibration     During key on, the signal voltage from the