RING-BACKUP 3576292 - Caterpillar

Illustration 4 g06181586
Illustration 5 g06181590Do not service the air conditioner system unless you are following the correct maintenance/repair procedures specified in the Service Manual.The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.1 kg (2.4 lb) of refrigerant which has a CO2 equivalent 1.573 metric ton.. The lubricating oil type for this system is PAG (polyalkylene glycol) 4C-2959 Air Conditioner Oil.Console Tilt (3) (If Equipped)This message is located on the front of the left console and on top of the left console.
Illustration 6 g01291705Fully raise the left console when you enter the cab and when you exit the cab.Data Privacy (4)This message is located in the cab.
Illustration 7 g01418953The Product Link System is a communication device that transmits information regarding the machine back to Caterpillar and Cat dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the CAT data link can be sent to the receiving station. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.The Product Link is also available in cellular format.Refer to Operation and Maintenance Manual, "Product Link" for more information.Cab Tilting (5), If EquippedThis message is located inside the access door below the cab on the left side of the machine. The message is located on the tilt pump.
Illustration 8 g01251686This message for the cab tilt pump indicates the proper operation of the cab tilt pump.Alternate Exit (6)This message is located on the inside of the right-hand side door.
Illustration 9 g01336895If the primary exit is blocked, exit the machine through the door on the right side of the machine.Diesel Fuel Requirements (7)One of the following messages is located next to the fuel filler cap.
Illustration 10 g02157153
Illustration 11 g02052934Use only Ultralow Sulfur Diesel (ULSD) fuel.The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability and will damage emissions control systems and/or shorten the service interval. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.Note: In Europe, diesel fuels that are identified as meeting "European Standard EN590:2004" requirements for ≤ 10 ppm sulfur fuel (a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur are typically referred to as “sulfur-free”. These fuels generally meet Cat requirements for ULSD fuel.Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information.Fuel Tank Water and Sediment Drain (8)This message is located inside the right fender at the bottom of the sediment pump, if equipped.
Illustration