RING-WEAR 3825756 - Caterpillar

Illustration 1 g06083452
Display
Illustration 2 g01223051
Assembly for the camera
System Overview
"Marker Line" - Your system provides the option in order to show a green horizontal "Marker" line on the display. The "Marker" line can be configured during installation or by a Caterpillar dealer technician. The "Marker" provides a fixed distance reference line from the machine. There are no operator controls that are available in order to adjust the "Marker". Refer to Illustration 3.
Illustration 3 g06100017
Rear camera view with marker
(1) "Marker"Power ON/OFF
Power is supplied to the system when the operator turns the keyswitch to the ON position. The system is design to provide the correct voltage to the display. The display will provide the correct voltage to the camera automatically. The power ON/OFF button that is on the display is disabled. Refer to Operation Section - "Display Description" for an illustration of the power button.Contact a Caterpillar dealer for electrical supply requirements.Overview of the Single Camera System
The WAVS single camera system only has one mode of operation which is automatic mode.
Illustration 4 g01372088
Example of a single camera installation on a Wheel Loader
(2) Rearward looking camera
(3) Possible route for the video cable
(4) Machine cab
(5) Display in cab
(6) Machine bucketNote: The orientation for the camera image is set during installation. The rear camera image is set to provide a reversed image which is similar to a mirror view.Overview of a Multiple Camera System
Illustration 5 g01372090
Example of the layout of the system on truck
(7) Machine cab
(8) Electrical compartment
(9) Location of the front camera
(10) Location of the right camera
(11) Location of the rear camera
(12) Routing of the cable for the camera
(13) WAVS display in machine cabFor a multiple camera system, WAVS has two modes of operation which are manual mode and automatic mode. Automatic mode is the preferred mode of operation. In the automatic mode, the display will provide a view from the camera that is defined by the configuration of the system during installation.Selection of Automatic Camera
In automatic mode, the view that will be shown on the display is determined by the following criteria:
The type of machine
The operator of the machineWAVS can be configured to respond to different types of automatic input or operator input.Note: For example, WAVS is configured to display the view from the rearward looking camera if an operator has selected reverse. When the operator has selected reverse, the view from the rearward looking camera will appear on the display.Machines such as the Off Highway Truck (OHT) may have a camera that is mounted on the right-hand side of the machine. Inorder to view the right-hand side camera on the display, the operator would manually press a momentary ON push button or a rocker switch. Refer to Operation and Maintenance Manual, "Modes of Operation". The illustration for the alternate camera switch shows an example of a type of rocker switch that has been installed.Note: The orientation for the image from the camera is set during installation. The rear camera image is set to provide a reversed image which is similar to a mirror view. Do not