RING-RETAINER 3D2975 - Caterpillar

Illustration 1 g00299479
Display AreaThe Numeric Readout Mode assists service personnel with information on the Load and Consumption. Also, information for troubleshooting of sensor inputs is provided. The information on Load and Consumption is only shown on the six digit display area. Mode 2 accurately shows information pertaining to the sensors that are being monitored.. The system identifier "PA-X" precedes the value that is shown on the display. Then, the parameter value is shown on the display. To enter Mode 2, hold the "CLEAR/MODE" Switch in the MODE position until "-2" appears on the display. Use the "SCROLL" switch in order to advance the display to the next parameter value. The display will momentarily show the identifier "PA-X". Then, the display will change to the value of the parameter.
Illustration 2 g00629400
Example Of The Display Area
Table 1
System Identification    
System Parameter     Harness Code "02"     Harness Code "15"     Harness Code "16"    
Boost Pressure     PA-1     PA-1     PA-1    
RH/LH Exhaust Temperature (1)     PA-2     PA-2        
Intake Manifold Temperature     PA-3     PA-3     PA-2    
Fuel Pressure     PA-4     PA-4     PA-3    
Aftercooler Coolant Temperature             PA-4    
RH/LH Air Filter Restriction Pressure (1)             PA-5    
Oil Filter Differential Pressure             PA-6    
Fuel Filter Differential             PA-7    
( 1 ) Uses a RH/LH toggle switch to view either RH or LH gauge and/or numeric readoutsNote: See Testing And Adjusting, "Harness Code - Troubleshoot" in order to identify the Harness Codes.
Table 2
Units    
Condition     Units of Measurement    
Temperature     °C, °F    
Pressure     kPa, psi    
Voltage     0.1 volts    
Engine Speed     rpm    
Instantaneous Fuel Consumption     L/Min, G/Min    
Total Fuel Consumption     Liters, Gallons    
Engine Hours     Hours    
Inlet Air Restriction     kPa, Inches of H2O    First, the display momentarily shows the system identifier. Then, the corresponding value is shown on the display. The scroll switch causes all of the systems to scroll on the display. The system identifiers are shown. Release the scroll switch when the desired input is shown in order to stop the scrolling. The display continues to show the system identifier. Then, the display changes in order to show the system value. The system is now shown on hold. The value is continuously updated while the display is on hold.