RING-INTERM. 3S4037 - Caterpillar

Illustration 16 g01295558
Apply Tooling (X) in the seal groove in impeller assembly (6) and on piston ring seal (10).
The turbine shaft must be clean and dry. Do not use grease, oil or any other lubricant on the turbine shaft.
Carefully put the compressor bearing assembly onto the turbine shaft.
Illustration 17 g01296085
While impeller assembly (6) is being held with Tooling (B), use an extension to tighten Tooling (F) into impeller assembly (6).
Illustration 18 g01296104
Use a 1/4 inch drive extension and a ratchet to install Tooling (T). Install Tooling (H), Tooling (S), and Tooling (R).
Illustration 19 g01296181
Connect Tooling (M) and Tooling (N). Apply pressure with Tooling (M) to install impeller assembly (6) onto the shaft assembly.
Illustration 20 g01296204
When movement stops, install Tooling (H) and Tooling (Y) to check the end clearance. The correct end clearance must be 0.10 to 0.20 mm (0.004 to 0.008 inch).
Remove Tooling (H) and Tooling (Y).
Illustration 21 g01296217
Use Tooling (Z) to measure the dimension from the outside edge of the impeller assembly to the step surface that is inside the impeller assembly. The dimension must be measured at four locations and the measurements must be equal.
Illustration 22 g01296225
Illustration 23 g01296267
Install screw (9) and the disc spring (washer). Install the washer with the concave face away from the screw head.
Use Tooling (B) and Tooling (D) to hold the impeller assembly and tighten screw (9) to a torque of 48 12 N m (35 9 lb ft).
Illustration 24 g01296292
Install Tooling (C) at three equally spaced locations into the gas outlet housing.
Keep the bearing housing in a vertical position so the turbine blades do not contact the insert (see photo inset).
Remove Tooling (C) and install the bolts.
Illustration 25 g01296365
Attach Tooling (A) and a suitable lifting device to compressor housing (4). The weight of compressor housing (4) is approximately 95 kg (209 lb). Be sure that Tooling (A) is engaged with the rib.
Install Tooling (C) at three equally spaced locations in compressor housing (4).
Install a new O-ring seal (40) on the bearing housing. Apply clean engine oil to O-ring seal (40).
Carefully install compressor housing (4) onto the bearing housing in the original position.
Remove Tooling (C) and install the bolts and washers.
Tighten the outer bolts to a torque of 58 12 N m (43 9 lb ft).
Tighten the inner bolts to a torque of 28 7 N m (21 5 lb ft).
Remove Tooling (A).
Illustration 26 g01296367
Install elbow (1) and bolts (2).
Install protective covers over all the turbocharger openings to protect the turbocharger before installation.
The turbocharger must be filled with oil prior to operation on the engine. After installation of the turbocharger on the engine, fill the turbocharger with clean engine oil at the oil supply port. Connect the oil supply line after filling.End By:
Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".