RING-RETAINING 4425726 - Caterpillar

Apply 5P-3321 Adhesive on the outside diameter of lip seal (16) (not shown).
Use Tooling (C) and a hammer in order to install lip seal (16) (not shown) into bearing retainer (6). Install lip seal (16) (not shown) until lip seal (16) (not shown) is flush with the face of bearing retainer (6).
Clean any excess adhesive from lip seal (16) (not shown) and bearing retainer (6).
Lightly lubricate lip seal (16) (not shown) with the lubricant that is being sealed.
Illustration 24 g00597945
Illustration 25 g00599594
Apply 5P-3321 Adhesive to the inside diameter of retainer (15).
Use Tooling (A) and Tooling (B) in order to install new retainer (15) onto hub assembly (11).
Press retainer (15) onto hub assembly (11) until retainer (15) is flush with the shoulder of hub assembly (11).
Clean any excess adhesive from retainer (15) and hub assembly (11).
Apply 5P-3321 Adhesive to the inside diameter of new wear sleeve (14).
Illustration 26 g00599776
Use Tooling (A) in order to install new wear sleeve (14) onto hub assembly (11).
Press new wear sleeve (14) onto hub assembly (11) until Tooling (A) stops on the shoulder of hub assembly (11).
Clean any excess adhesive from wear sleeve (14) and hub assembly (11).
Illustration 27 g00597943
Illustration 28 g00623609
Use Tooling (H) and a hammer in order to install new bearing (13) into hub assembly (11).
Install bearing (13) until the edge of bearing (13) is recessed 6 mm to 7 mm (0.25 inch to 0.28 inch) from ledge (X) of the bore in hub assembly (11).
Use Tooling (H) and a hammer in order to install new sleeve bearing (12) into hub assembly (11).
Install bearing (12) until the edge of bearing (12) aligns with the bottom of the chamfer on the splined end.
Illustration 29 g00597984
Use Tooling (C) and a hammer in order to install hub assembly (11) into bearing retainer (6).
Illustration 30 g00597940
Install snap ring (10) into bearing retainer (6).
Illustration 31 g00599801
Position splined hub (9) onto hub assembly (11). Use Tooling (J) in order to install snap ring (8). Install snap ring (8) in order to secure splined hub (9) to hub assembly (11).
Illustration 32 g01032086
Install Tooling (K) and a suitable lifting device to bearing retainer (6).
Lower bearing retainer (6) onto pulley adapter (7). The weight of bearing retainer (6) is approximately 32 kg (70 lb).
Illustration 33 g00597937
Install bolts (5) and the washers that secure bearing retainer (6) to pulley adapter (7).
Tighten bolts (5) to a torque of 25 2 N m (18 2 lb ft).
Illustration 34 g00597936
Position adapter (4) and the O-ring seal to the hub assembly. Install eight screws (3) that secure adapter (4) and the O-ring seal to the hub assembly.
Illustration 35 g00597935
Attach a suitable lifting sling (not shown) around fan pulley (2). Secure the suitable lifting sling to a hoist.
Position fan pulley (2) onto the pulley adapter. The weight of the pulley adapter is approximately 131 kg (289 lb). The weight of fan pulley (2) is approximately 55 kg (121 lb).
Install eight bolts (1) that secure fan pulley (2) to the pulley adapter.
Tighten bolts (1) to a torque of 52 6 N m (38