RING-SNAP 4747635 - Caterpillar

6. Put tube assemblies (3) and bracket (4) in position. Install wire clip (5) and ground wire (6). 7. Connect tube assemblies (3) to the hydraulic control valve, and connect hose assemblies (7). 8. Connect hose assembly (8). Install bracket (9) and wire clip (10). Rotate lifting eye (11) to the down position. 9. Check the seal and gasket, and install gauge tube (12) and filler tube (13). Install two clips (14). 10. Install bracket (15). Put valve (16) in position, and bolt it to bracket (15). Connect hose assemblies (17) and (18). 11. Put manifold (19) in position, and fasten it to the transmission case. Connect two hose assemblies (20), (21) and (22) to the manifold. 12. Check the O-ring seals in the face of transmission control cable brackets (23). Install the rod ends in the slots of the shift spools, and bolt brackets (23) to the transmission case.13. Using the transmission shift lever on the steering column, check that all directional and speed positions can be felt. For more information on adjusting the transmission control cables, see Transmission Control Linkage Adjustments in Power Shift Transmission Testing And Adjusting section.14. Put two brake lines (24) in position, and install clips (25) and (26) (behind firewall). 15. Connect brake lines (24) to the brake master cylinders and to the tube assemblies behind the firewall. 16. Install parking brake tube and switch assembly (27) and clip (31) for the governor control cable.17. Connect wire connector (28) and the wires to the directional control switches (29) and parking brake switch (30). 18. Put governor cable control housing (32) in position, and install two bolts (33). Slide lever (34) on the governor shaft aligning the marks made during disassembly. Install the gasket and cover. For more governor cable adjustment information, see Governor Pedal And Housing Group in the Operator's Station Disassembly And Assembly section. 19. Install hose assemblies (35) and (36).20. Install tube assembly (37) from the hydraulic control valve to the hydraulic tank. 21. Install pump suction tube assembly (38).22. Install the implement pump outlet tube assembly (39) and bracket (40).23. Install the steering pump outlet tube assembly and test elbow (41).24. After the machine is completely assembled, remove (bleed) the air from the brake system. See Remove Air From The Wheel Brake Hydraulic Circuit (Bleed The Brakes) in Systems Operation.25. If the transmission oil was drained, fill it with oil. See the Maintenance Guide.END BY:a. install cab *b. install supplemental steering pump **c. install drive shaft (center)d. install drive shaft (rear)e. install parking brake chamber ***This operation is in the Operator's Station Disassembly And Assembly section.**This operation is in the Vehicle Systems Disassembly And Assembly section.Separate Torque Converter Transmission And Transfer Gears
START BY:a. remove torque converter, transmission and transfer gears 1. Install a nylon strap on the hydraulic oil pump (1), and fasten a hoist. Remove two bolts (2) and pump assembly (1). The weight is 27 kg (60 lb.).2. Remove cover (3). 3. Remove fitting (4) and the