RING 4J7376 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the installation of new components due to normal wear and aging. The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant Extender (ELC) - Add
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Walk-Around Inspection
Initial 250 Service Hours
Engine Valve Lash - Check
Every 250 Service Hours
Air Shutoff - Test
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Grounding Stud - Inspect/Clean/Tighten
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 2000 Service Hours or 1 Year
Alternator - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Engine Valve Lash - Check
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Electronic Unit Injector - Check/Replace
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Every 6000 Service Hours or 6 Years
Coolant Temperature Regulator - Replace
Every 8000 Service Hours or 3 Years
Driven Equipment - Check
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Every 14 400 L (3750 US gal) of Fuel or 250 Service Hours or 1 Year
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 28 500 L (7500 US gal) of Fuel or 500 Service Hours or 1 Year (Deep Sump)
Engine Oil and Filter - Change
Every 114 000 L (30 000 US gal) of Fuel or 1500 Service Hours
Battery Electrolyte Level - Check
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours
Aftercooler Core - Clean/Test
Every 170 400 L (45 000 US gal) of Fuel or 3000 Service Hours
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Engine Valve Rotators - Inspect
Fan Drive Bearing - Lubricate
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations
Overhaul
Fan Drive Bearing - Replace