RING (standard) 4M1633 - Caterpillar

Every attempt is made to provide accurate, up-to-date information. By use of this document you agree that Caterpillar is not responsible for errors or omissions.
These recommendations are subject to change without notice. Contact your local Cat dealer for the most up-to-date recommendations.
Lubrication System
Lubricant Recommendations
Due to significant variations in the quality and in the performance of commercially available oils, Caterpillar recommends the following oils:
Cat DEO (Diesel Engine Oil) (10W-30)
Cat DEO (Diesel Engine Oil) (15W-40)
Cat DEO-ULS (Diesel Engine Oil - Ultra Low Sulfur) (15W-40)Commercial Oils
Note: Non-Cat commercial oils are as a group second choice oils. This group of second choice oils are rated by performance.
Caterpillar does not warrant the quality or performance of Non-Cat fluids.
Caterpillar developed the Engine Crankcase Fluid (ECF) specifications in order to ensure the availability of high performance commercial diesel engine oils. When the high performance commercial diesel engine oils are used properly, the availability of the high performance commercial diesel engine oils provides satisfactory life in Cat Diesel Engines. Note: If Cat DEO multigrade or DEO-ULS multigrade oils are not used, use only commercial oils that meet the following categories/specifications:
Commercial oils that meet the requirements of the Cat ECF-1-a, Cat ECF-2, and/or the Cat ECF-3 specification are acceptable for use in Cat diesel engines that are covered by this Operation and Maintenance Manual. API category oils that have not met the requirements of at least one Cat ECF specification may cause reduced engine life.
Commercial oils that meet the requirements of the Cat ECF-3 specification or meet the requirements of the API CJ-4 oil category are the preferred commercial alternative oils for use in all Cat diesel engines that are covered by this Operation and Maintenance ManualOils that meet the requirements of the CJ-4 API category are compliant with the Cat ECF-3 specification.The following categories of oils are not approved for use in your Caterpillar Engine: API CF, API CF-4 and API CG-4.
Do not use single grade API CF oils or multigrade API CF oils in Cat 3500 Series Engines.
Engine Oil Viscosities
In selecting oil for any engine application, both the oil viscosity and oil performance category/specification as specified by the engine manufacturer must be defined and satisfied. Using only one of these parameters will not sufficiently define oil for an engine application.
The proper SAE viscosity grade of oil is determined by the minimum ambient temperature during cold engine start-up. The proper SAE viscosity grade of oil is also determined by the maximum ambient temperature during engine operation. To determine the oil viscosity that is required for starting a cold soaked engine, refer to the minimum temperature in Table 1. To select the oil viscosity for operation at the highest anticipated ambient temperature, refer to the maximum temperature in the Table. Use the highest oil viscosity that is available in order to meet the required temperature during start-up.
Table 1
Engine Oil Viscosities for Ambient Temperatures
Ambient Temperature
Viscosity Grade Minimum Maximum
SAE 0W-20 −40 °C (−40 °F) 10 °C (50 °F)
SAE 0W-30 −40 °C (−40 °F) 30 °C