RING-BACK UP 4Z8550 - Caterpillar

TARGET="_parent">Fuel System Primary Filter (Water Separator) - Drain
Fuel System Primary Filter (Water Separator) - Drain
Tire Inflation - Check
Initial 250 Service Hours (or at first oil change)
Engine Valve Lash - Check/Adjust
Every 250 Service Hours
Engine Oil Sample - Obtain
Every 250 Service Hours or Monthly
Articulation Bearings - Inspect
Articulation Chassis Cable - Inspect/Replace
Battery Electrolyte Level - Check
Collet Pin Bolt Torque - Check
Differential and Final Drive Oil Level (With Axle Oil Cooler) - Check
Differential and Final Drive Oil Level (Without Axle Oil Cooler) - Check
Drive Shaft Universal Joints, Splines and Bearings - Inspect/Lubricate
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) - Replace
Fuel System Primary Filter (Water Separator) - Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Lift Arm Support Pins - Clean
Rear Axle Trunnion Bearings - Inspect
Steering Stop - Check
Every 500 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Coolant Sample (Level 2) - Obtain
Differential and Final Drive Oil Sample - Obtain
Hydraulic System Oil Sample - Obtain
Transmission Oil Sample - Obtain
Every 500 Service Hours or 3 Months
Differential Thrust Pin - Check/Adjust
Fuel Tank Breather - Replace
Fuel Tank Cap and Strainer - Clean
Hydraulic System Oil Filter - Replace
Oil Filter (Pilot) - Replace
Transmission Oil Filter - Replace
Every 1000 Service Hours or 6 Months
Brake Accumulator - Check
Differential and Final Drive Oil (With Axle Oil Cooler) - Change
Differential and Final Drive Oil (Without Axle Oil Cooler) - Change
Ride Control Accumulator - Check
Rollover Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) - Inspect
Solenoid Valve (Parking Brake) - Test
Transmission Oil - Change
Transmission Oil - Change
Every 2000 Service Hours or 1 Year
Alternate Exit - Inspect/Replace
Brake Release System - Test
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Overspeed Control - Check
Engine Valve Lash - Check/Adjust
Engine Valve Rotators - Inspect
Hydraulic System Oil - Change
Hydraulic Tank Breaker Relief Valve - Clean
Refrigerant Receiver-Dryer - Replace
Transmission Mounts - Inspect
Turbocharger - Inspect
Every 3000 Service Hours or 2 Years
Cooling System Coolant Extender (ELC) - Add
Cooling System Pressure Cap - Clean/Replace
Engine Aftercooler - Check
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 6000 Service Hours or 3 Years
Cooling System Coolant (ELC) - Change
Cooling System Water Temperature Regulator - Replace
Engine Water Pump - Inspect