RING 5332014 - Caterpillar

Do not bend or add stress to the shaft when nut is loosened or tightened.
(6) Thickness of each thrust ring ... 2.72 to 2.74 mm (.107 .108 in)(7) Bore in housing (new) ... 19.050 to 19.063 mm (.7500 .7505 in) Outside diameter of the bearing (new) ... 18.948 to 18.961 mm (.7460 to .7465 in)Maximum permissible clearance between bearing and bore in housing (worn) ... 0.15 mm (.006 in)Torque for four nuts (put 5P3931 Anti-Seize Compound on threads) and bolts that hold turbocharger to exhaust manifold ... 55 5 N m (40 4 lb ft)Torque the bolts that hold compressor housing to the center section ... 6.8 N m (60 lb in)Torque the bolts (put 5P3931 Anti-Seize Compound on threads) that hold turbine housing to the center section ... 15 to 17 N m (132 to 150 lb in) Put clean engine oil in the oil inlet of the turbocharger after assembly or before installation to provide start up lubrication and/or storage protection.S3B
(1) End play for shaft (new) ... 0.102 0.025 mm (.004 .001 in) Maximum permissible end play (worn) ... 0.20 mm (.008 in)(2) Thickness of thrust bearing (where thrust rings contact bearing) ... 5.36 0.03 mm (.211 .001 in)(3) Diameter of shaft (new) ... 12.697 to 12.705 mm (.4999 to .5002 in) Bore in bearing (new) ... 12.741 to 12.748 mm (.5016 to .5019 in)Maximum permissible clearance between bearing and shaft (worn) ... 0.05 mm (.002 in)(4) Maximum permissible gap of oil seal ring, measured in bore of housing ... 0.25 mm (.010 in)(5) Install the compressor wheel (at room temperature) as follows: a. Put compressor wheel on the shaft.b. Put a small amount of clean engine oil on the threads.c. Tighten the nut to 14 to 17