RING (SNAP) 5M3624 - Caterpillar

Illustration 1 g00412261
Display Area For Submode 25 (1) Submode Identifier. (2) Status Identifier.
Enter submode 25 (hydraulic system pressure switch check). Press and hold the "SERVICE" switch. Release the switch when "25" is showing on submode identifier (1).
Move the tilt lever back and forth from the HOLD position to the TILTBACK position. Status identifier (2) should change from "11" to "00" between the HOLD and TILTBACK position.
"00" means that the tilt lever is in the TILTBACK position.
"11" means that the tilt lever is NOT in the TILTBACK position.Expected Result: The status identifier (2) shows the correct value as the lever is moved from the HOLD position to the FULL TILTBACK position. Results:
YES - The circuits for the hydraulic system pressure switch are working correctly. Change to a different submode or return the Caterpillar Monitoring System and the hydrostatic transmission ECM to normal mode. To change to a different submode, press and hold the "SERVICE" switch. Release the switch when the number of the submode that is desired is showing on identifier (1). To return to normal mode, press and hold both the "SERVICE" switch and the "CLEAR" switch at the same time. Release the switches when the symbol that resembles a hour meter is shown in the display.
NO - Refer to Diagnostic Function, "Pressure Switch (Pilot) for the Hydraulic System".