RING-METAL SEAL 6N0009 - Caterpillar

Engine: C18 (S/N: CYN1-UP) C9 (S/N: C9A1-UP)Introduction
This document should be used with the electrical schematic and the troubleshooting manual for the installation. The document provides information for wiring the engine electronics and programming the engine electronics. The installation guide should be fully read before you start the installation. This will help you understand the requirements in order to complete the installation.The troubleshooting manual will have following information:
System overview
Electronic Service Tool
Sensors and electrical connectorsReference: Electrical Schematic, RENR7937, "C18 Marine Engine Electrical System "Reference: Electrical Schematic, RENR8119, "C9 Marine Engine Electrical System"Reference: Troubleshooting, RENR5032, "C9 Marine Auxiliary Engine"Reference: Troubleshooting, RENR5013, "C18 Marine Engine"Reference: Special Instruction, REHS2566, "Programming ECM Governor Gain Parameters"Reference: Operation and Maintenance Manual, SEBU7912, "C9 Marine Auxiliary and Generator Set Engines"Reference: Operation and Maintenance Manual, SEBU7917, "C18 Marine Auxiliary Engine "Reference: Service Manual, SENR5002, "Installation Guide for Marine Engine Electronic Displays"Reference: Service Manual, RENR7651, "Marine Multi-Station Control System"Important Safety Information
Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills and tools in order to perform these functions properly.Improper operation, maintenance or repair of this product may be dangerous. Improper operation, maintenance or repair of this product may result in injury or death.Do not operate or perform any maintenance or repair on this product, until you have read the operation, maintenance and repair information. Do not operate or perform any maintenance or repair on this product, until you understand the operation, maintenance and repair information.Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this publication and on the product are not all inclusive. If a tool, a procedure, a work method or an operating technique that is not specifically recommended by Caterpillar is used, you must be sure that it is safe for you and for other people. You must also be sure that the product will not be damaged. You must also be sure that the product will not be made unsafe by the procedures that are used.The information in this publication was based upon current information at the time of publication. The specifications, torques, pressures, measurements, adjustments, illustrations, and other items can change at any time. These changes can affect the service that is given to the product. Caterpillar dealers will have the most current information.
When replacement parts are required for this product Caterpillar recommends using Caterpillar replacement parts or parts with equivalent specifications including, but not limited to, physical dimensions, type, strength and material.Failure to heed this warning can lead to premature failures, product damage, personal injury or death.
Required Tools
Table 1
Required Service Tools    
Part Number    Description    
1U-7563     Hex Key Wrench    
1U-5804     Crimp Tool (12 to 18 AWG)    
7X-1710     Multimeter Probes    
9U-7330
or
146-4080     Digital Multimeter
Digital