RING-PLUNGER 7C1511 - Caterpillar

Telemetry Parameters
From the top level of the display, you can scroll through the logs and the telemetry data. Navigation is accomplished with the soft keys. The keys are located at the bottom of the display and the keys are located on the right side of the display.
Table 1
Three Phase Telemetry Points    
"Input Line Voltage A, B, and C"     Measurement of the input voltages from phases A, B, and C to neutral.    
"Phase - Phase Input Volts A, B, and C"     Measurement of the phase voltage to the phase voltage. The measurement is made on the input side across phases A, B, and C.    
"Current In Phases A, B, and C"     Input current to the system, measured for each phase A, B, and C.    
"Input Power Phases A, B, and C"     Calculated value based on the input phase to neutral voltages and the input currents.    
"Input kVA Phases A, B, and C"     Calculated value based on the input phase to neutral voltages and the input currents.    
"Output Line Voltage Phases A, B, and C"     Measurement of output voltages from phases A, B, and C to neutral.    
"Phase - Phase Output Volts A, B, and C"     Measurement of the phase to phase voltages from output phases A, B, and C.    
"Current Out Phases A, B, and C"     Output current from the system, measured for each phase A, B, and C.    
"Output Power Phases A, B, and C"     Calculated value based on the output phase to neutral voltages and the output currents.    
"Output kVA Phases A, B, and C"     Calculated value based on the output phase to neutral voltages and the output currents.    
Table 2
Single Phase Telemetry Points    
"Frequency"     Measurement of the frequency as seen on phase C.    
"Output Power"     Sum of the output power on phases A, B, and C.    
"Total Output kVA"     Sum of the output kVA on phases A, B, and C.    
"Output Power Factor"     Calculated value based on the output phase to neutral voltages and the output currents.    
"Input Frequency"     Measurement of the input frequency as seen on phase C.    
"Total Input Power"     Sum of the input power on phases A, B, and C.    
"Total Input kVA"     Sum of the input kVA on phases A, B, and C.    
"Input Power Factor"     Calculated value based on the input phase to neutral voltages and the input currents.    
"Cabinet Temp"     Air temperature measurement taken in the cabinet.    
"Air Inlet Temp"     Air temperature taken at the air inlet to the cabinet    
"Static Switch Temp"     Temperature of the static switch heat sink.    
"Positive DC Bus Voltage"     Positive DC bus voltage produced by the input rectifier.    
"Negative DC Bus Voltage"     Negative DC bus voltage produced by the input rectifier.    
"Tachometer"     Flywheel tachometer.    
"Percent