RING 7N6606 - Caterpillar

Attachment Lift Lever
Float (1) - Push the lever all the way forward into detent, for FLOAT. The attachment will lower to the ground, and move up and down, following the ground contour.The lever will remain in FLOAT until pulled out of detent. The lever will then return to HOLD when released.
NEVER use FLOAT position to lower a loaded bucket.Machine damage can result from bucket falling too fast.
Float detent is not on machines equipped with load check system. LOWER (2) - Push the lever forward to lower the attachment. The lever will return to HOLD when released. HOLD (3) - The lever will return to HOLD when released from either RAISE or LOWER. The attachment will remain in the position it is in. RAISE (4) - Pull the lever back to raise the attachment. Release the lever to stop lifting the attachment. The lever will return to HOLD when released.The lever is detented in the full raise position. It will stay in detent and continue raising, until the attachment reaches height set by the lift kickout. Then it returns to HOLD.Attachment Tilt Lever
DUMP (1) - Push the lever forward to tilt the attachment forward. When released the lever will return to the hold position and the attachment will remain in the tilt forward position. HOLD (2) - Release the tilt lever. The attachment will remain in the position it is in. TILT BACK (3) - Pull the lever back to tilt the attachment back. Bucket Tilt Back - Press the top of the switch to select the preset angle for the bucket. Fork Tilt Back - Press the bottom of the switch to select the preset angle for the forks.The lever will stay in detent and continue tilting back, until the attachment reaches the preset angle set by the kickout. Then it returns to HOLD. The tilt back kickout only functions if the attachment is tilted lower than the preset angle. The detent will work anytime the power switch is ON, but the kick out switch will only work if the attachment starts at a position below the preset angle.Hydraulic Control Lever Lock
Lock (1) - Turn the handle counterclockwise to lock the hydraulic control levers. Unlock (2) - Turn the handle clockwise to unlock the hydraulic control levers.Attachment Function Control Lever (Third Valve Function Only)
Move the lever to the valve closed position to divert flow to the attachment. Pull the lever back to pressurize the left supply line and control the attachment rotation in one direction.Push the lever forward to pressurize the right supply line and control the attachment rotation in the other direction. See the Operating Techniques section in this publication for more detailed instructions.Attachment Coupler (Third Valve Function Only)
Move the lever to the valve open position to provide flow to the coupler. Disengage (1) - Move the lever to position (1) to disengage the coupler pins. Release the lever and it will return to hold. Hold (2) - Release the lever and the pins will remain in