RING-WEAR 8C9153 - Caterpillar

This Systems Operation manual is written to provide information for the overview and configuration of the Marine Classification Society (MCS) Alarm and Protection (A&P), MCS controller and Remote Equipment Interface (REI).This manual has been published primarily for professionals and qualified personnel. The user of this material is assumed to have basic knowledge in marine systems.Note: Caterpillar products are continuously upgraded and reserves the right to change and improve without prior notice. All information in this manual is based upon information at the time of printing. For the latest information, refer to SISWeb.This manual is valid for the following firmware releases of the DCU and RP.
Table 1
Panel    Firmware    Release Date    
DCU 410     2.5     July 2012    
RP 410     2.5     July 2012    Important Safety Information
Do not perform any procedure in this Systems Operation manual until you have read this Systems Operation and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this publication and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe.Ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance, or repair procedures used.