RING-WEAR 8T7692 - Caterpillar

Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood. To determine the maintenance intervals, use fuel consumption, service hours, or calendar time, which ever occurs first.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.Note: Some maintenance items are for optional equipment.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Storage Procedure - Check
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Severe Service Application - Check
Daily
Cooling System Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Every 3000 Service Hours or 3 Years
Cooling System Coolant (DEAC) - Change
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
First 13 000 L (3400 US gal) of Fuel or 250 Service Hours
Engine Valve Lash - Inspect/Adjust
Every 13 000 L (3400 US gal) of Fuel or 250 Service Hours
Aftercooler Core - Clean/Test
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Electronics Grounding Stud - Inspect/Clean/Tighten
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Air Cleaner Element (Single Element) - Replace
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 26 000 L (6800 US gal) of Fuel or 500 Service Hours
Engine Crankcase Breather - Clean
Fuel System Primary Filter (Water Separator) Element - Replace
Every 153 500 L (40 500 US gal) of Fuel or 3000 Service Hours
Air Compressor - Inspect
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Every 256 000 L (67 500 US gal) of Fuel or 5000 Service Hours
Alternator - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Overhaul
Overhaul Considerations