RING 9J9818 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 2P-8312 Retaining Ring Pliers 1
B 8H-0663 Bearing Puller Gp 1
C 1P-0510 Driver Gp 1
Turn the fuel supply to the “OFF” position and turn the power disconnect switch to the OFF position.
Illustration 1 g02155173
Disconnect tube assemblies (1) and (2).
Remove bolts (4).
Remove fuel transfer pump (3) and remove the O-ring seal (not shown).
Illustration 2 g02155430
Remove nut (5). Remove bolts (7) and remove pump drive (6).
Illustration 3 g02155446
Remove bolts (10) and retainers (11) that secure adapter (14) to bearing (12).
Use Tooling (A) in order to remove retaining ring (13).
Use Tooling (C) and a suitable press to remove assembled bearing (12) and gear (9) from adapter (14).
Use Tooling (B) and a suitable press in order to remove bearing (8) from gear (9).
Use Tooling (B) and a suitable press in order to remove bearing (12) from gear (9). Installation Procedure
Install the fuel transfer pump in reverse order.
Illustration 4 g02155446
Raise the temperature of bearing (8) and install the bearing onto gear (9).
Raise the temperature of bearing (12) and install the bearing onto gear (9).
Use Tooling (C) and a suitable press in order to install assembled bearing (8), bearing (12), and gear (9) into adapter (14).
Turn the fuel supply to the “ON” position and turn the power disconnect switch to the ON position.
Remove the air from the fuel system. Refer to Testing and Adjusting, "Fuel System - Prime".