RING-METAL SEAL 9P5364 - Caterpillar

Transmission: TA19 (S/N: XAE1-UP; XAF1-UP)Introduction
Table 1
Revision     Summary of Changes in REHS3622    
02     Updated arrangement numbers in Table 2.
Updated Introduction.
Added "Think Safety" graphic.    © 2015 Caterpillar All Rights Reserved. This guideline is for the use of Cat dealers only. Unauthorized use of this document or the proprietary processes therein without permission may be violation of intellectual property law.This special instruction contains the necessary information that is required to bench-test specific transmission arrangements. Refer to Table 2 for the correct arrangements. Bench testing the transmission ensures correct assembly and operation of the component. Rotating a transmission provides the most conclusive evaluation. Testing allows the dealer to ensure that the transmission will operate properly in the machine. The specifications in this guideline are specific to bench testing the component. Every effort has been made in order to provide the most current information that is known to Caterpillar. Continuing improvement and advancement of product design might have caused changes to your product which are not included in this publication. This guideline must be used with the latest technical information that is available from Caterpillar.For questions or additional information concerning this guideline, submit a form for feedback in the Service Information System. In order to address an urgent need, use the following resources to communicate your request to Caterpillar Repair Process Engineering:
Cat Dealer Techinical Communicator
Dealer Solution Network
Cat Technical Representative
Knowledge Network
Table 2
Sales Model    Transmission Arrangement    
TA19-4WD     317-5322
317-5323    Canceled Part Numbers and Replaced Part Numbers
This document may include canceled part numbers and replaced part numbers. Use NPR on SIS for information about canceled part numbers and replaced part numbers. NPR will provide the current part numbers for replaced parts.Collecting the Test Data
Since conditions vary for the test bench, use data that is collected from your test bench. The collected data is used to compare test results. The data should be collected and maintained by the operator.Data from each transmission arrangement is collected and stored. Averages from each transmission arrangement are used in order to compare values on portions of this transmission test. Always compare data that is collected from the same transmission arrangement that is being tested. Averages for the last 20 transmission arrangements should be maintained.
Illustration 1 g02139237
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue and cause serious injury and possible death. If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.Always use a board or cardboard when checking for a leak.
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Personal injury or death can result from not following the proper procedures.To avoid the possibility of injury or death, follow the established procedure.
Tools Needed
Note: Pressures will be sensitive to tooling setup. The diameter of the hose, the diameter of a fitting, and additional filtering can affect pressure. The required tools that are