RING 9T5068 - Caterpillar

Start By:a. remove crankshaft rear seal and wear sleeveb. remove electric starting motor1. Remove the bolts that hold the oil pan plate to the flywheel housing. Loosen the bolts that hold the oil pan plate to the cylinder block.2. Install spacers between the oil pan plate and the cylinder block to hold the oil pan plate away from the flywheel housing. 3. Remove the bolts and two engine supports (4) from the flywheel housing.4. Install tooling (A) on the flywheel housing as shown, and fasten a hoist to it.5. Remove all bolts (1) and flywheel housing (3) from the engine. The weight of the flywheel housing is 37 Kg (82 lb). The following steps are for installation of the flywheel housing.6. Clean the old gasket from the surfaces of the cylinder block and flywheel housing that make contact with each other. Install a new gasket on the cylinder block.7. Install two 1/2 " - 13 NC guide bolts (2) in the cylinder block.8. Use tooling (A) and a hoist to position flywheel housing (3) on the cylinder block. 9. Install all bolts (1) that hold the flywheel housing, and tighten them in the sequence shown to a torque of 100 14 N m (75 10 lb ft).10. Cut the bottom of the flywheel housing gasket off even with the cylinder block and flywheel housing. Put 5H2471 Gasket Cement on the bottom of the gasket where it makes contact with the oil pan gasket.11. Remove the spacers from between the oil pan plate and the cylinder block. Tighten the bolts that hold the oil pan plate to the cylinder block. Install the bolts that hold the oil pan plate to the flywheel housing.12. Install two engine supports (4), and the twelve bolts that hold them. Tighten the bolts to a torque of 135 15 N m (100 11 lb ft).End By:a. install electric starting motorb. install crankshaft rear seal and wear sleeve