RING-BACKUP 9X7278 - Caterpillar

Ensure that all safety information, warnings and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICHEVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Generator - Dry
Generator Set - Test
Rotating Rectifier - Test
Severe Service Application - Check
Daily
Annunciator Panel - Inspect
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Power Factor - Check
Walk-Around Inspection
Every Week
Bearing Temperature - Measure/Record
Electrical Connections - Check
Generator - Inspect
Generator Lead - Check
Instrument Panel - Inspect
Every 2000 Service Hours or 6 Months
Generator Set Vibration - Inspect
Insulation - Test
First 9500 L (2500 US gal) of Fuel or 250 Service Hours
Engine Valve Lash - Inspect/Adjust
Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or Yearly
Aftercooler Core - Clean/Test
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Magnetic Pickups - Clean/Inspect
Radiator - Clean
Rotating Rectifier - Check
Every 19 000 L (5000 US gal) of Fuel or 500 Service Hours
Fuel System Primary Filter (Water Separator) Element - Replace
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Alternator - Inspect
Crankshaft Vibration Damper - Inspect
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 3 Years
Alternator - Inspect
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Engine Mounts - Inspect
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 228 000 L (60 000 US gal) of Fuel or 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Overhaul
Overhaul Considerations