RIPPER GP-D 2750925 - Caterpillar

Limited Slip Differential 926 and 930
The limited slip differential is a locking differential. The limited slip differential is designed to provide equal power to both wheels. Equal power will be provided to both wheels until the ground conditions cause a variance in traction between the left wheel and the right wheel. The limited slip differential transfers lost power from the wheel with the least traction to the wheel with the most traction.The limited slip differential is a direct replacement for the standard differential. The limited slip differential is available in the rear axle group only.
Illustration 1 g00280829
Limited Slip Differential
(1) Case housing. (2) Thrust washer. (3) Clutch pack. (4) Actuator housing. (5) Side gears. (6) Pinion (gears). (7) Pinion (gears). (8) Pinion shafts.
Illustration 2 g00280828
Locking Ratio
(4) Actuator housing. (8) Pinion shaft. (9) 45 degree angle.
When the wheels have equal traction, the limited slip differential sends an equal amount of power to both of the wheels. One wheel begins to turn faster than the other wheel if there is a loss of traction. When traction loss occurs, the internal forces that are present between shaft (8) and actuator housings (4) will react on 45 degree angle (9). The internal forces push actuator housings (4) against clutch packs (3). The torque of the clutch pack limits the loss of traction to the wheel that is turning faster.The locking effect is due to the internal friction of the differential. This effect is produced by two clutch packs (3) which are arranged symmetrically in the differential housing. In a standard differential, one wheel can be held in position when the engine is running and a gear is engaged. The other wheel will turn faster. In the limited slip differential, the above procedure would be more difficult because of clutch packs (3). The above procedure will become more difficult as power increases.The limited slip differential is identical on the left side and the right side of two pinion shafts (8). The limited slip differential contains the following components: two thrust washers (2), two clutch packs (3), two actuator housings (4), two bevel gears (5) and four pinion gears (7).The inside splines of side gears (5) are connected to the sun gears for the final drives. The outside splines of side gears (5) are meshed with the inner friction discs in clutch packs (3). The side gears send the power through the sun gears and to the final drives.Housing (1) is fastened to the bevel gear. Housing (1) has inner grooves which hold the outer discs. The outer discs are in clutch pack (3). The clutch pack also has inner discs between the outer discs. The inner discs are splined to the side gears. Actuator housings (4) also fit in the same grooves. The actuator housings are held with the discs from moving radially. Side gears (5) fit into actuator housings (4). Pinion shafts (8) also fit into actuator housings (4). The pinion shafts lie in the 45 degree notches in the load ring. Pinion gear (6)