RIPPER AR 3852715 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-1834     Bearing Puller Adapter     1    
4C-9634 Puller Stud     1    
9U-6832 Nut     1    
6V-3170 Double Acting Cylinder     1    
3S-6224 Electric Hydraulic Pump Gp     1    
4K-0684 Hard Washer     1    
9S-8546 Seal Installer     1    Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Lower the blade to the ground.
Retract the centershift lock pin. Refer to the appropriate Operation and Maintenance Manual for the correct procedure.
Release the hydraulic system pressure. Refer to the appropriate Disassembly and Assembly Manual for the correct procedure.
Illustration 1 g01009664
Disconnect harness assemblies (1) and (2). Disconnect hose assemblies (3) .
Remove bolts (5) and remove centershift lock (4) .
Illustration 2 g01010208
Attach a suitable lifting device to centershift lock bar (9) .
Remove bolts (6) and lock (8). Remove pin (7). Lower centershift lock bar (9) on the drawbar.
Illustration 3 g01009687
Illustration 4 g01009666
Remove seal (12). Use Tooling (A) in order to remove bushing (11) from front frame assembly (10) .