RIVET 0010507 - Caterpillar

Blade Pitch
To carry out a calibration for the Blade Pitch Sensor, complete the following steps:
Illustration 1 g01247200
Illustration 2 g01247369
Select "Calibrate Sensor" from the "Setup Menu - Configuration" menu.A window that is similar to Illustration 2 appears.Note: The machine must be on a level surface and the blade must be located in the operating position.The "Calibrate Sensor" dialog shows the current blade pitch reading from the sensor.
Press "Calibrate".The Blade Pitch Sensor is calibrated. The "Calibrate Sensor" dialog is closed. The "Setup Menu - Configuration" dialog appears.Before you move the blade, use the steps that follow in order to check the blade pitch calibration:
Use the up arrow or the down arrow until "Calibrate Sensor"s is highlighted. Press "OK".The "Calibrate Sensor"s dialog appears.
Use the up arrow or the down arrow until "Blade Pitch Sensor" is highlighted.
Press "OK".The "Calibrate Sensor" dialog appears again.
Confirm that the blade pitch reading shown in the dialog is zero.