RIVET-BLIND BK 4871095 - Caterpillar

(32) Joystick Control (33) Speed 1 and Speed 2 (34) Differential Lock (35) Forward/Neutral/Reverse Control (36) Proportional 3 - Auxiliary Hydraulics (37) Continuous FlowFloat Enable and Disable Modes - Default setting from the factory the float function is enabled. If required it is possible to Disable and or Enabled the Float depending on the operators requirements.The following steps explain how to disable and or enable.
Push the Implement Lockout Switch to disable the implements.
Move the joystick to 100% forward into the full detent position and back to HOLD 3 times in quick succession within 1 second.
The LED Float Indicator Lamp on the front display will blink 3 times to indicate that the above step has been successful and changed the status as required.
To confirm that the correct status has been achieved (Enabled or Disabled) push the Implement Lockout Switch to enable the implements and then in a safe area perform an operation check to see if the Float function is activated or deactivated and changed to the required status.FLOAT - There are 2 activation methods for float.
Operator holds float position.
Locked float activation position.
Operator Holds FloatPush the lever fully forward as far as it will travel to engage the detent position, this will activate float control. When the lever is moved into the detent, the operator will feel a slight change in the required effort to push the joystick into the detent. Releasing the joystick back to the hold position will stop the float control.Note: This can only be held for 60 seconds as it will automatically release after that time.
Locked Float ActivationPush the lever fully forward through to the detent position and immediately release the joystick to allow it to return to the HOLD position. This will activate float and float willmaintained until a command to cancel it is made. To cancel this locked float position, move the joystick control to the lift position and when you see any movement of the loader the float will have been canceled.Note: In both cases when activating/deactivating float function the indicator light on the front display will flash 3 times.In both cases when float is active then the LED light indicator on the front display will be lit.LOWER - Push the joystick forward.HOLD - The joystick will return to this position when the joystick is released.Rack Back Positioner (If Equipped) - Switch on the Keypad Control needs to be activated first to allow Rack Back Positioner to operate. Move the joystick lever fully to the left into the detent to activate the Rack Back Position.When the operator moves the joystick lever to the detent position, the operator will feel a slight effort change to push the joystick into the detent position. Once the detent position has been reached, release the lever which will return to the HOLD position, Rack Back Position will now be activated.To override/cancel the Rack Back Position the joystick lever must be moved at least 25% from HOLD in either left or right movement. The Kick Out Position