RIVET-POP 9M5733 - Caterpillar

Caterpillar Products All MachinesIntroduction
This Special Instruction provides information for installation of the 237-5920 Service Kit. The operation of the Machine Security System is covered in the Systems Operation, RENR2462, "Machine Security System (MSS)". Refer to that manual for more information.The MSS Universal Attachment Kit is intended for use on all products (Caterpillar or other manufacturer) that are without the MSS Custom Kit.Do not perform any procedure that is outlined in this publication, or order any parts until you understand this information.Note: Before you install the Machine Security System on a machine, check for other electronic control modules on the machine. Machines that are equipped with other electronic control modules must NOT use the Machine Security System to disable the "MAIN POWER" of the machine. This will prevent the Machine Security System from disabling the other electronic control modules on the machine in the event of a failure of the Machine Security System.Note: The Advanced Machine Security System is a Software Enabled Attachment (SEA). To add this attachment, the "Advanced Machine Security" status must be "Installed" in the ECM configuration (Caterpillar Electronic Technician (Cat® ET) and factory password required).Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar is used, ensure that it is safe for you and for other people to use.Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures that are used.Required Tools
The following tools will be required to install the Machine Security System. The list below contains the recommended Caterpillar service tools.
Table 1
Part Number Description
151-0968 Cordless Drill Gp (12 V, 3/8 inch, Variable Speed)
1U-5893 Drill Bit Set (135 Degree Split Point)
9S-1748 Socket Wrench Set (1/2 Inch Drive)
199-6156 Socket Wrench Set (1/2 Inch Drive-Metric)
194-3584 Socket Wrench Set (Torx)
1U-7230 Hand Tool Gp (Screwdrivers)
8T-9293 Torque Wrench (1/2 inch Drive)
1U-7123 Adapter
190-8900 Connector Repair Kit (DT)
- 1 5/16 inch Hole Saw
- 13 mm (1/2 inch) to 25 mm (1 inch) Universal Drill Bit
- Center Punch Parts List
Table 2
Contents of the Retrofit Kit for the Machine Security System
All parts are contained in the 237-5920 Service Kit.(1)
Quantity Part Number Description
2 3E-5239 Relay Assembly
1 225-8513 Harness Assembly