ROCKER ARM AS 1566953 - Caterpillar

1566953 ROCKER ARM AS Caterpillar parts 3013, 302.5, CB-214D, CB-334D, CB-335D

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1566953
156-6953
1566953

Weight: 2 pounds 1 kg.

Buy ROCKER ARM AS 1566953 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE, VIBRATORY COMPACTOR,

Compatible equipment models: 1566953:

INDUSTRIAL ENGINE 3013

MINI HYD EXCAVATOR 302.5

VIBRATORY COMPACTOR CB-214D CB-334D CB-335D Caterpillar

Number on catalog scheme: 5

Caterpillar 1566953 Parts scheme ROCKER ARM AS

For full view, you need register

Information:

Illustration 1 g02854936
Label with the injector code
Illustration 2 g02132457
Sequence for recording the injector code
The electronic service tool is used to load the injector codes into the ECM.The injector codes must be loaded into the ECM if any of the following conditions occur:
An electronic unit injector is replaced.
The ECM is replaced.
Diagnostic code 630-2 or 268-2 is active.
Electronic unit injectors are exchanged between cylinders.Note: Diagnostic code 630-2 or 268-2 will also become active if the engine serial number, FLS, or FTS are not entered into the ECM.If the ECM is replaced, the injector codes are normally transferred to the new ECM as part of the "Copy Configuration" procedure. If the "Copy Configuration" procedure fails, the injector codes must be loaded manually.Installing Injector CodesNote: The injector code is on the electronic unit injector.
Record the injector code for each electronic unit injector.
Connect the electronic service tool to the diagnostic connector. Refer to Troubleshooting, "Electronic Service Tools".
Turn the keyswitch to the ON position.
Select the following menu options on the electronic service tool:
Service
Calibrations
Injector Trim Calibration
Select the appropriate cylinder.
Click the "Change" button.
Input the applicable injector code that was recorded in Test Step 1.
Click the "OK" button.The injector code is loaded into the ECM.
Repeat the procedure for each cylinder, as required.Exchanging Electronic Unit InjectorsExchanging electronic unit injectors can help determine if a combustion problem is in the electronic unit injector or in the cylinder. If two electronic unit injectors that are currently installed in the engine are exchanged between cylinders, the injector codes must also be exchanged. Press the "Exchange" button at the bottom of the "Injector Trim Calibration" screen on the electronic service tool. Select the two electronic unit injectors that will be exchanged and press the "OK" button. The tattletale for the electronic unit injectors that were exchanged will increase by one.