ROD 0038089 - Caterpillar

Illustration 1 g00037860
Typical example
Mount the machine and dismount the machine only at locations that have steps and/or handholds. Before you mount the machine, clean the steps and the handholds. Inspect the steps and handholds. Make all necessary repairs.Face the machine whenever you get on the machine and whenever you get off the machine.Maintain a three-point contact with the steps and with the handholds.Note: Three-point contact can be 2 feet and one hand. Three-point contact can also be 1 foot and two hands.Do not mount a moving machine. Do not dismount a moving machine. Never jump off the machine. Do not carry tools or supplies when you try to mount the machine or when you try to dismount the machine. Use a hand line to pull equipment onto the platform. Do not use any controls as handholds when you enter the operator compartment or when you exit the operator compartment.
Illustration 2 g02711294
Location of the ground level service center
After daylight hours end or in periods of darkness, use the platform access lighting . This light illuminates the entrance way to the cab. Open the access door to the ground level service center.
Illustration 3 g02368820
Ground level service center
Access Lighting - Use the toggle switch for the lighting in order to mount the machine.Note: When the switch in the ground level service center is activated, the lights remain on for 10 minutes. The time limit of the lights is programmable in the Monitoring System Display with “Machine Setup” in the Settings Menu. Toggling the switch a second time will deactivate the lights. The toggling of the switch will also turn off the lights if the lights were activated from the cab while exiting the machine.Delayed Lighting ModeEnable this function by leaving the Forward ROPS lights in the ON position before turning the machine keyswitch to the OFF position. The lights will remain ON for a configured amount of time (10 minute default). Use the access lighting switch to turn OFF the lights, if necessary.