ROD 0967717 - Caterpillar

Illustration 1 g00785241
(1) Mounting panel
Remove the bolts and the washers from mounting panel (1) .
Illustration 2 g00785243
(1) Mounting panel (2) 6T-1767 Toggle Switch (3) 7N-8008 Toggle Switch
Position mounting panel (1) in order to access the toggle switches.
Disconnect the following cables from 7N-8008 Toggle Switch (3) : EL343-yellow from terminal 1 and EL343-yellow from terminal 3. Trim the EL343-yellow cable that was removed from terminal 1. Install heat shrink tubing over the end that is trimmed.
Illustration 3 g00801348
(2) 6T-1767 Toggle Switch (3) 7N-8008 Toggle Switch (4) Manufactured cable
Use two 2L-8065 Terminals and use 100 mm (3.9 inch) of 16 AWG cable in order to manufacture a new cable (4). Connect the manufactured cable (4) to terminals 2 and 5 on 6T-1767 Toggle Switch (2) .
Illustration 4 g00801337
Revised wiring code for S/N:AD/AE40-101 to 128
Refer to Illustration 4 for the revised wiring code for S/N:AD/AE40-101 to 128
.
Illustration 5 g00801338
Refer to Illustration 5 for the revised wiring code for S/N:AD/AE40-129 and Up
.