ROD 0970787 - Caterpillar

Carefully remove existing stud bolt (S) and install bracket (8) using stud bolts (22). The existing washer should be in between the isolation mount and the bracket (8) .
Attach Cable Assembly (9) and jump-start receptacle assembly (10) to the starter.Note: Cable Assembly (9) should be closest to the starter.
Illustration 14 g03081121
Install grommet (7), clips (5) and (6), and ladder clip (11) using bolt (21) and washer (19) .Note: The clips should contact the bracket (8) first, followed by the ladder clip (11), and then the washer (19) .
Illustration 15 g03080481
(P) Existing 208-1569 Hose As
Illustration 16 g03080600
(P) Existing 208-1569 Hose As
Remove existing hardware and attach clip (1) with stud bolt (16) and washer (13). Then install grommet (12), clips (17) and (18), on cable assembly (9) and attach to stud bolt (16) using washers (13) and nut (14) .
Illustration 17 g03080605
(P) Existing 208-1569 Hose As
Remove existing bolt and washer connecting front ground strap to the case and frame. Rotate the ground strap connector 180 degrees so the flat side (T) of the connector is closest to the center of the tractor as shown in Illustration 17.
Illustration 18 g03080658
Remove paint (U) from both sides of bracket (4) near the bottom bolt hole.
Illustration 19 g03080637
Install grommet (12), clips (17) and (18), to cable assembly (10). Then attach clips (17) and (18) to bracket (4) with bolt (21) and washer (19) .
Illustration 20 g03080718
Attach bracket (4) using bolt (20) and washer (19) as shown in Illustration 19. Make sure the front ground strap (W) is removed and rotated in order to contact the boss welded to the case and frame as shown in Illustration 20.Note: Paint should be removed from bracket (4) per Step 22 and installed on top of the ground strap (W) .
Illustration 21 g03775477
Route receptacle cable assembly (10) to final location and install four tie straps (15) .
Illustration 22 g03081198
Route cable assembly (9) and cable assembly (3) to final position at location (AD) and install one tie strap (15) on each cable. Route cable assembly (9) and cable assembly (3) to final position at location (AC) and install two tie straps (15) on each cable. Route cable assembly (9) and cable assembly (3) to final position at location (AA) and install one tie strap (15) on each cable.Note: Installing two straps is important at location (AC) and positioning cable (3) and cable (9) so the cables do not contact the edge of the frame rail at location (AB) .Note: Use appropriate tool (1U-5227) in order to tighten straps.
Illustration 23 g02780637
Connect cable assembly (9) to battery pass through block using existing hardware.
Illustration 24 g03081201
Route cable assembly (3) to final position and install three tie straps (15). Then attach cable assembly (3) to fuse panel using hardware removed in step 5.Note: Use appropriate tool (1U-5227) in order to tighten straps.
Reinstall fuse panel covers, seat suspension, seat, and man hole cover.
Reinstall engine enclosures.