ROD AS-CONN 0R2929 - Caterpillar

Torque for all (1/4 in) locknuts (jam nuts) that hold the rod ends on the cables ... 8 3 N m (6 2 lb ft)Torque for all (5/8 in) jam nuts ... 38 7 N m (28 5 lb ft)(A) Neutral lock position ... 77 mm (3 in)(E) Dimension ... 95.0 mm (3.75 in)(3) Assembled length of rod assembly ... 146.0 mm (5.75 in)(11) Apply 7M7260 Liquid Gasket between cover and housing. (17) Use shims as required to obtain end play of ... 0.025 to 0.100 mm (.0010 to .004 in)Adjustment of Transmission Control Linkage
1. Disconnect yoke (13) on cable assembly (15) from lever.2. Disconnect yoke (12) on cable assembly (16) from lever.3. Check length of cable assemblies (15) and (16) inside housing (14). Make adjustments as needed to dimension (E).4. Move direction control spool (6) to the FORWARD position against stop (7) by pulling out on cable assembly (15).5. Move speed selector spool (8) to the NEUTRAL position against stop (9) by pushing in on cable assembly (16).6. Adjust set screw (4) for neutral lock lever (10) to dimension (A).7. Move speed control lever (5) until it contacts neutral lock lever (10).8. Make adjustments, as needed, to the length of rod assembly (2) and/or yoke (12) on cable assembly (16) until the pin can be installed in the lever.9. Adjust the length of rod assembly (3) to 146 mm (5.7 in) from center to center of rod end ball.10. Install yoke (13) on cable assembly (15) with pin.11. Move transmission neutral lock lever (10) to the OPERATING position (pulled up).
Transmission Selector Lever on the Forward Side of the Neutral Opening
(1) Transmission selector lever. (18) Shift guide.12. With the cover removed from housing (14), move transmission selector lever (1) to all positions indicated on shift guide (18). A detent must be felt in each position. Also check to make sure that the jam nuts on the cables do not make contact with the shields on the cables. Final adjustment, if needed, may be obtained by doing one of the following: a. Loosen the cable that needs adjusting at the housing on the fuel tank console and move the cable in or out to obtain the desired adjustment.b. Loosen the housing at the transmission (shown in View D-D) and thread the housing in or out to obtain the desired adjustment.
(15) Direction cable. (16) Speed cable.(F) ... Forward(G) ... Reverse(H) ... 25.4 mm (1.00 in)(J) ... Neutral Position(K) First Speed Position ... 12.7 mm (.50 in)(L) Second Speed Position ... 25.4 mm (1.00 in)(M) Third Speed Position ... 38.1 mm (1.50 in)