ROD AS-CONNECTING 1608192 - Caterpillar

Procedure To Install Rotate Carriage Groups
Illustration 1. Carriage Group. 8I-5950 Carrier Assembly (11). 083-8422 or 083-8158 Carriage Assembly (10).
Illustration 2. Area (A) Carrier Assembly Pivot Shaft1. Remove rotate carriage (10) from carrier assembly (11). Only one 6R-7934 Thrust Washer is required during assembly. Discard 081-5789 Back-up Washers.2. Install 6R-7934 Thrust Washer (1) onto the carrier pivot shaft.3. Assemble carriage (10) to carrier (11).4. Install thrust washer (3), steel back-up washer (4) and nut (5).5. Tighten nut (5) to 10 N m (89 lb in) minimum.6. Check axial clearance (A) between thrust washer (3) and the carriage boss using a feeler gauge. Axial clearance (A) should be 0.75 - 1.75 mm (.030 - .070 in). If necessary, remove thrust washer (3), steel back-up washer (4) and nut (5). Install 9R-8390 Steel Shims (2) as needed at location C. Shims (2) can also be added at location (D), when required.7. Tighten nut (5) to 10 N m (89 lb in). 8. Repeat steps six and seven until clearance (A) is correct. Tighten nut (5) to 20 N m (177 lb in). Install Split Pin (6)9. Push the carriage (10) on the pivot shaft towards the carrier (11).Near wear pad (9), pry the carriage away from the carrier as far as possible. Measure Dimension (B), between wear pad (9) and the carrier. A maximum gap of 0.75 mm (.030 in) is allowed.10. Add 089-7342 Shim (7) 0.75 mm (.030 in) and 089-7343 Shim (8) 1.5 mm (.060 in) as necessary.