ROD AS-CONNECTING 1656076 - Caterpillar

Illustration 42 g00487484
Strike the pump drive gears with a soft faced hammer in order to seat the pump drive gears into the bearing cones. Repeat Step 35.
The following steps illustrate the procedure that is used in order to determine the thickness of shim pack (10) :
Illustration 43 g00537727
Insert a depth micrometer into one of the three holes that are located on bearing cage (6). Record the measurement. Repeat for the remaining two holes. Calculate the average of the three measurements. Record the average measurement.
Remove six bolts (5) and the washers in order to remove bearing cage (6) from pump drive housing (1) .
Use an outside micrometer in order to measure the thickness of the shaft flange at three equally spaced locations. Calculate the average of the three measurements. Record the average measurement.
Subtract the measurement that was recorded in Step 37.c from the measurement that was recorded in Step 37.a. Record the measurement. This measurement is the average gap between bearing cage (6) and pump drive housing (1) .
In order to determine the thickness of shim pack (10), add 0.1 mm (0.004 inch) to the measurement that was recorded in Step 37.d. This measurement is the required thickness of the shim pack. Use an outside micrometer in order to assemble shim pack (10) .
Illustration 44 g00537728
Install shim pack (10) onto bearing cage (6). Install O-ring seal (8) onto bearing cage (6). Use six bolts (5) and the washers in order to install bearing cage (6) onto pump drive housing (1). Tighten six bolts (5) to a torque of 47 9 N m (34.67